EC centrifugal fans backward curved, single inlet, Ø 560 Highlights: – 7-blade fan, 3-phase fan motor – 10 VDC max. output / 10 mA, 24 V external program input, 0-10 VDC / PWM control input – Integrated PID controller, control interface with SELV potential safely disconnected from the mains, RS485 MODBUS RTU technology – Over-temperature protected electronics / motor – Soft start, PFC passive, line undervoltage / phase failure detection Material: Impeller: Aluminum sheet Rotor: Coated in black Electronic housing: Die-cast aluminum Mounting position: Shaft horizontal or rotor on bottom; rotor on top on request Condensate discharge holes: Rotor-side Direction of rotation: Clockwise, seen on rotor (1) Nominal data at maximum load. Measurement: LU-128639 Air performance measured as per: ISO 5801, Installation category A, without protection against accidental contact. Suction-side noise levels: L W A as per ISO 13347, L P A measured at 1m distance to fan axis. The values given are valid under the measuring conditions mentioned and may vary accoring to the actual installation situation. With any deviation to the standard set-up, the specific values have to be checked and reviewed once installed or fitted. For detailed information on the measuring set-up, please contact ebm-papst. Curves n rpm Pe W I A (460V) I A (230V) L w A dB(A) Nominal Data Nominal voltage range Frequency Power input (1) Speed (1) Current draw (1) Temperature range (1) Mass I ngress protection rating Electrical wiring diagram UL Approval Type K Module Motor VAC Hz Watts RPM A °C lbs R3G560-AQ11-19F EG1R-240-560-60 M3G150-NA 200...240 50/60 4,700 1,750 14 -25...40 90 IP54 B Yes R3G560-AQ04-09F EG1R-480-560-60 M3G150-NA 380...480 50/60 4,700 1,750 7.3 -25...40 90 IP54 B Yes 0 2.000 4.000 6.000 8.000 9.000 cfm 0 0.4 0.8 1.2 1.6 2 2.4 2.8 3.2 3.6 4 4.4 4.8 5.2 5.6 in. wg 2.000 4.000 6.000 8.000 10.000 12.000 14.000 16.000 m3/h pfs[Pa] pfs[Pa] pfs[Pa] 1400 1300 1200 1100 1000 900 800 700 600 500 400 300 200 100 0 1 2 3 4 5 6 7 8 9 10 11 12 A A A A A A A A A A A A 1750 3032 4.8 9.6 97 1750 3929 6.1 12.2 91 1750 4700 7.3 14.6 84 1750 4366 6.7 13.4 86 1450 1675 2.6 5.2 93 1450 2171 3.4 6.8 87 1450 2602 4.0 8.0 80 1450 2432 3.7 7.4 82 1150 836 1.3 2.6 88 1150 1083 1.7 3.4 82 1150 1298 2.0 4.0 75 1150 1213 1.9 3.8 76