dsdfsa Zoomed in view… Fasteners Assignment Part C: 3/8-16 UNC-2A 1.5 FLAT HEAD.

• dsdfsa

Zoomed in view…

Fasteners AssignmentPart C: 3/8-16 UNC-2A 1.5 FLAT HEAD

Check PDF packet page one for quick reference

to page numbers…

Start by drawing the following vertical

rectangle .375x1.5

• Offset top line down ½ D (0.1875)• Draw a line from the blue circle intersection

heading “@1<50”• Mirror angled line over to the left side of

the fastener and fillet, trim, extend, / erase.

Add slot for screw driver. Dimensions for height and width are 1/4D as

noted in the book example.

• Check last page of PDF for dimensions of steel plates.

• Top plate has a clearance hole for the fastener.

• Bottom plate is tapped (threaded)- See page 1 of PDF for page number referencing

threaded holes• Bottom plate has more threads cut than

length of bolt, i.e. bolt can’t bottom out without fully tightening down.

• Pilot hole (pre-drilled hole before tapping can occur) extends lower than threads and has 80 degree angle (same as the twist drill bit that cut the hole). Dimensions can be

“eye balled.”