5910 Disk Boot Failure Issue If you get a screen saying ‘Disk boot failure, insert system disk and press enter’, follow the below instructions. 1. Disconnect all devices from the back of the tower unit including the mains power cable and make sure the rocker switch is turned off with the ‘0’ position pressed in. 2. Remove the two case screws from the back of the tower unit too and slide the side panel off. 2 case screws that need removing Rocker switch Side panel
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
5910 Disk Boot Failure Issue If you get a screen saying ‘Disk boot failure, insert system disk and press enter’, follow the below instructions.
1. Disconnect all devices from the back of the tower unit including the mains power cable and make sure the rocker switch is turned off with the ‘0’ position pressed in.
2. Remove the two case screws from the back of the tower unit too and slide the side panel off.
2 case screws that need removing
Rocker switch
Side panel
Inside the PC there will be a loose hard disk power cable.
Hard disk drive Loose power cable
3. Pull out the power cable so it is full loose then plug it back into the correct port shown below, it will only fit one way and the port is located behind where the red/ink SATA cable is positioned.
4. Reconnect the side panel and case screws and plug the relevant cables into the back of the tower unit again, flip the rocker switch back to the on position ‘1’ and power the PC on as normal. The PC will now boo into Windows normally ready to be setup.
SATA cable Correctly fitted hard disk drive power cable
Related Documents
![Operating Systems: Processes and Threads disk boot sector !RAM reset address processor starts executing contents Boot-sector code: load kernel code from disk sectors to RAM, ... XXX]v}](https://static.cupdf.com/doc/110x72/5ace74497f8b9a56098bd136/operating-systems-processes-and-threads-disk-boot-sector-ram-reset-address-processor.jpg)
![PRIMERGY RX100 環境設定シート...Resume Day [ ] Resume Time [ ] Restart on AC/Power Failure Restore Last Power State ... Always Power Off Boot Sequence 1st. Floppy Disk A: Hard](https://static.cupdf.com/doc/110x72/5f30ef4ce680897ca810e652/primergy-rx100-cfeff-resume-day-resume-time-restart.jpg)
