Disassembling Macintosh IIsi Power Supply...Information on the power supply: It was made by Sony in 1990, and uses a 10-Pin power connector. Disassembling Macintosh IIsi Power Supply
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Disassembling Macintosh IIsi Power Supply作成者: Chris Green
Disassembling Macintosh IIsi Power Supply 下書き: 2015-10-20ガイド ID: 2283 -
The Macintosh IIsi Uses a 120/240V AC Power Supply. It provides power directly to the logic board.From there, it is distributed to the rest of the computer.
ツールツール:Phillips #0 Screwdriver (1)
Disassembling Macintosh IIsi Power Supply 下書き: 2015-10-20ガイド ID: 2283 -
The "SuperDrive" is mounted similarly to the hard drive, and positioned right next to it.
Push these two tabs out, and lift the drive up.
手順手順 4
Flip the drive so it is on top of the power supply, and remove the "Red-Ribbon" cable.
1.44MB floppy drives need a ribbon cable with a red stripe on one side. 400KB floppy drives use aribbon cable with a yellow stripe on one side. 800KB floppy drives can use a red, or yellow stripedcable.
This drive was manufactured by Sony in 1990.
Disassembling Macintosh IIsi Power Supply 下書き: 2015-10-20ガイド ID: 2283 -
To remove the power supply, squeeze these two tabs and lift the front up.
On the back of the power supply, there is a tab that also must be pressed to remove the powersupply fully. You can then lift it out all the way. A firm tug may be necessary to seperate the powerconnector.
Disassembling Macintosh IIsi Power Supply 下書き: 2015-10-20ガイド ID: 2283 -