ICS 83.060 Elastomere – Bestimmung des Druckverformungsrestes bei Umgebungs-, erhöhten oder niedrigen Temperaturen (ISO 815 : 1991 + Corrigendum 1 : 1993) This standard incorporates International Standard ISO 815 Rubber, vulcanized or thermoplastic – Determination of compression set at ambient, elevated or low temperatures (including Technical Corrigendum 1 : 1993). A comma is used as the decimal marker. National foreword This standard has been prepared by ISO/TC 45. The responsible German body involved in its preparation was the Normenausschuss Materialprüfung (Ma- terials Testing Standards Committee), Technical Committee Prüfung der physikalischen Eigenschaften von Kautschuk und Elastomeren. The DIN Standards corresponding to the International Standards referred to in clause 2 of the ISO Standard are as follows: ISO 471 DIN ISO 471 ISO 4648 DIN 53534 ISO 4661-1 DIN ISO 4661-1 Amendments DIN 53517, April 1987 edition, has been superseded by the specifications of DIN ISO 815. Previous editions DIN 53511-3: 1940x-12; DIN 53517: 1960-07, 1987-04; DIN 53517-1: 1972-01; DIN 53517-2: 1972-01. National Annex NA Standard referred to (and not included in Normative references) DIN 53534 Determination of the linear dimensions of rubber test pieces and products Ref. No. DIN ISO 815 : 2000-03 English price group 09 Sales No. 0409 07.00 DEUTSCHE NORM March 2000 ISO 815 { ISO Standard comprises 11 pages. © No part of this standard may be reproduced without the prior permission of DIN Deutsches Institut für Normung e. V., Berlin. Beuth Verlag GmbH, 10772 Berlin, Germany, has the exclusive right of sale for German Standards (DIN-Normen). Vulcanized and thermoplastic rubber Determination of compression set at ambient, elevated or low temperatures (ISO 815 : 1991 + Technical Corrigendum 1 : 1993) Supersedes DIN 53517, April 1987 edition.