This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Product Overview
TM
Speci�cations
DEVIL WATT Water Cooled Thermoelectric GeneratorDW-WC-50W
Page 1 of 4
Part Number
Hot Side Temperature
Matched Load Output Power
Open Circuit Voltage
Matched Load Output Voltage
Matched Load Current
Dimension Size
Weight
DW-WC-35W
270 C (518 F)o o
50W
24V DC
12V DC
4.2A
9.0 lbs (4.1 kgs)
Water Cooled Thermoelectric Generator
DW-WC-50W
12.7in x 5.7in x 2.1in (325mm ×146mm × 55mm)
Output Performance
20
10
40
60
Temperature of the hot side / Co
The Devil Watt 50 watt thermoelectric power generator is designed with mounting holes so it can be �ush mounted toa gas, wood or coal stove for supplemental power generation or an industrial appliance for waste heat recovery. The generator is cooled by circulating water/glycol through the inside and to radiators, baseboard heaters, radiant tubing or other heat exchangers. The generator can be attached to a heat source to generate hotwater and electricity. The thermoelectric power generator consists of 4 Tegpro Thermoelectric modules, one aluminum heat receiving plate and a liquid cooling block. The aluminum plate conducts the heat from the heat source surface to the hot side of the thermoelectric module. Some of the heat �owing through the thermoelectric modules passes to the liquid cooling block where it is removed by �owing water/glycol through the system. The rest of heat isconverted by the thermoelectric modules to electricity.
The generator is installed with 4 Tegpro 19 Watt 56 mm × 56 mm modules connected in a series circuit. When the generators’heat receiving plate reaches 270 °C (518 °F) and the entering water temperature is 30 °C (3/4 GPM �ow rate), the generator can produce 50 watts. See the graph below to determine power generation at lower heat receiving plate tempearatures. The generator is light-weight, produces no noise and is very durable. Max hot sidetemperature is 450 C. Never run without water/glycol cooling or unit will be damaged.
1. There are 8 mounting holes in the hot plate of the generator, please a�x to a smooth �at surface on your heat source with high temperature fasteners.2. The generator can be installed horizontally or vertically just make sure all the air is out of the system before starting it.3. You can install several units to produce more output power. Always make sure that the water/glycol is �owing through this unit when heat is applied.