Function: Compressed air will flow through the ejector D and create a vacuum in the pump casing and suction line. After priming, the pumps will build up pres- sure in the discharge line which will activate the presure switch F . The presssure switch then dis- connect the power to the solenoid valves E and the priming stops automati- cally. At a fluid pressure of e.g. 10 m total head the unit will disconnect automati- cally (adjustable from 3 - 100 m total head). If the pressure drops to less than 10 m total head the unit will automatically start functioning until a counter pressure has been reestablished. DESMI priming ejector DESMI Danmark A/S Tagholm 1 DK-9400 Nørresundby Phone: + 45 72 44 02 50 Fax: + 45 98 17 54 99 Internet: www.desmi.dk E-mail: [email protected] The DESMI priming ejector is designed for mounting on non-selfpriming centrifu- gal pumps thus making the pump unit self-priming. In order to make the unit work, the delivery pipe has to be shut off, e.g. by means of a non-return valve A Drain B Air Inlet C Check valve D Ejector E Solenoid valve F Pressure switch G Connection with suction line D E A F C B E G