Deep Sea Electronics Installation Manual

0

DEEPSEA Configuration and Installation Guide DEEPSEA ELECTRONICS MODULE Installation and monitoring manual for Genset

Prepared by: USAID PDP Infrastructure Team 1

Table of Contents Summary Information: .................................................................................................................................. 2

How to install Deep Sea Electronics PLC Software to monitor Genset? ....................................................... 3

Getting started with DSE Suit ........................................................................................................................ 6

Login Credentials Info? ................................................................................................................................. 8

How to view Power Information’s? .............................................................................................................. 9

How to view Logs? ...................................................................................................................................... 10

How to Start/Stop Remotely? ..................................................................................................................... 10

How to access DSE Installer Setup from NAS? ............................................................................................ 11

Prepared by: USAID PDP Infrastructure Team 2

Summary Information:

Genset IP Address: 10.10.8.33

Genset Manufacturer: Orient

Genset Module: Deep Sea Electronics

Vendor: Interactive Group

Prepared by: USAID PDP Infrastructure Team 3

How to install Deep Sea Electronics PLC Software to monitor Genset? Click the setup file named as ATS Configration-Suit-installer

Now execute Setup and install the software as shown below:

Read the license agreement for the Virtual Serial Port software supplied by Tibbo Technology Inc. Click I

AGREE to continue.

Prepared by: USAID PDP Infrastructure Team 4

Accept the default settings and click NEXT

Accept the default settings and click INSTALL

Prepared by: USAID PDP Infrastructure Team 5

The driver

installs...

Select REBOOT NOW and click FINISH to reboot your computer and complete the installation process.

You cannot use the DSE860/5 connection until the PC has been rebooted.

Prepared by: USAID PDP Infrastructure Team 6

Getting started with DSE Suit Now to desktop shortcut icons named as DSE Configuration Suit and open it.

In the Following Screen, now follow these steps:

Goto

connect via ->

Tibbo Virtual Serial Port

Serial Setting ->

Baud Rate : 9600

Tick Enable 485

Tick x86 Support

After Selecting above options click Read Configuration from a module. It will read configuration from

the module.

Now this is the main screen of DSE Suit

Prepared by: USAID PDP Infrastructure Team 7

On Left pane Click the Scada and it will connect to the generator and shows all the details about

genetaor e.g OIL gauge, Power, Voltages , Current & Event logs etc..

Prepared by: USAID PDP Infrastructure Team 8

This is the Main display of generator and it shows the current status of the generator.

Login Credentials Info? If your software is protected with the password then the screen will ask the password

Username: mepco

Password: mepco

Note: Mepco is a limited user to gain admin access kindly contact

AD (MIS)/Data Center In charge.

Click ok after entering Password to it, go to startup screen then

follow the steps mentioned in getting started with DSE Suit

Prepared by: USAID PDP Infrastructure Team 9

How to view Power Information’s? Power information can be viewed from the

7310 Scada -> generator -> Frequency Voltages and Current

Power information can be viewed from the 7310 Scada -> generator -> Power

Prepared by: USAID PDP Infrastructure Team 10

How to view Logs? Event Logs can be viewed from the

7310 Scada -> Event Logs

It will view all the logs and can be export to excel and pdf files.

How to Start/Stop Remotely? If you want to start generator remotely then click 7310 Scada -> Mimic it will show the main Generator

screen and now using control you start or stop generator remotely.

Prepared by: USAID PDP Infrastructure Team 11

How to access DSE Installer Setup from NAS?

Go to run and enter NAS IP click ok

Double click on shared folder

Double click on Genset Simulator folder

Prepared by: USAID PDP Infrastructure Team 12

Double click on ATS configuration-suite-installer and the suite will start installation.