YOU WILL NEED: • Die’sire ‘Ivy’ Die • Die’sire ‘Holly’ Die • Die’sire ‘ Christmas Bows’ Die • Embossalicious ‘Let it Snow’ A4 embossing folder (coming July ‘13) • A3 Centura Pearl Snow White Silver • Spray & Sparkle ‘Iridescent’ • Collall 3D Glue Gel • Core’dinations Super Assortments - Roy G Biv • Core’dinations pack - Gemstones • Red Mirri Card from Hunkydory • Christmas patterned paper • 8” x 8” card base DECK THE HALLS By Sharon Callis Step 1 Cut a sheet of cream Core’dinations card to measure 20cm x 20cm and stick it to the card base. Cut a sheet of green Gemstone card to measure 19.5cm x 19.5cm and layer it on top of the cream base. Cut a sheet of patterned paper to measure 18.5cm x 18.5cm and emboss with the ‘Let it Snow’ folder. Spray with the Spray & Sparkle and layer on top of the green paper. Step 2 Die-cut a few pieces of the large and small ivy from green Core’dinations card from the Roy G Biv pack. Using the Collall 3D glue gel, start to arrange the ivy in a circle. Build up layer after layer until you have a good depth. Step 3 The centrepiece at the top of the wreath is made using the Holly and Christmas bows dies. Cut one large and three small Holly shapes from a light tone of Core’dinations, then cut some berries and the two sizes of Christmas bow from the mirri card. Distress the holly leaves and stick the berries in place. Layer the holly pieces over each other and hold in place with Collall 3D Glue Gel. Finish with the die-cut bows on top and stick this topper to the wreath to complete the card.