Cscape 9.6 - SP3, Free PLC Software: Updated: June 10, 2015 Cscape Free PLC software combines graphical ladder diagram programming (based on IEC-1131) with operator interface development to completely integrate the control package. It’s straightforward approach to programming by combining logic with messaging and networking. Cscape Programmable Logic Controller Software is absolutely free to download. You’ll need to register for an account to get started. Be sure to use a valid e-mail address as the final download link will only be sent to confirmed accounts. This is available for download from the Software Download section of the US web site: http://www.heapg.com/content/10-cscape-software page European web site: http://www.horner-apg.com/en/download/ocs.aspx [Notice: Past users can download the upgrade under My Account.] Who should download Cscape 9.6 - SP3? Please note: Cscape 9.6 - SP2 was not released. • Users downloading Cscape for the first time. • All Users of the X-Series Controllers. • Users who wish to utilize the product enhancements listed below Horner APG attempts to ensure full upward compatibility for new releases of Cscape. However, prior to deploying any new software package, users should take necessary steps to validate that the new software does not introduce problems in their application. Carefully read these steps prior to downloading and installing Cscape 9.6 - SP3: • If you choose to install Cscape 9.6 and retain previous versions of Cscape, you must move the previous versions to new folder(s) prior to installing Cscape 9.6. • Backup all application files (.csp) prior to using Cscape 9.6. Once application files are saved in Cscape 9.6, they can no longer be opened with previous versions of Cscape. • Horner APG attempts to ensure full upward compatibility for new releases of Cscape. However, prior to deploying any new software package, users should take necessary steps to validate that the new software does not introduce problems in their application. • Cscape 9.10B added an “Auto Update” from the Internet feature. This is currently being used to install service packs only. If you currently have Cscape 9.6 SP1, this method will be used to acquire the new Service Pack 3 (SP3). Although SP3 is not a new install please insure that the same backup precautions are used pertaining to programs created with SP1, programs opened and saved in SP3 will NOT be compatible with SP1. • If you currently do not have Cscape 9.6 SP1 and wish to upgrade to the newest version SP3, download Cscape 9.6 SP1 and use the auto updater to upgrade to SP3, please follow prior instructions when installing a new version of Cscape as outlined.