Page 1 of 13 CREO 2.0 LIST OF PRACTICALS TO BE PERFORMED practical1. Introduction and revision of modelling tools to be used in creo parametric Practical 2. Modelling of different components of the cotter joint.
Sep 10, 2015
Page 3 of 11
CREO 2.0 LIST OF PRACTICALS TO BE PERFORMED
practical1. Introduction and revision of modelling tools to be used in creo parametric
Practical 2. Modelling of different components of the cotter joint.
PRACTICAL 3. Assembly of different components of the COTTER joint.
PRACTICAL 4. Modelling of different components of the KNUCKLE JOINT
Practical 5 . Assembly of different components of the KNUCKLE JOINT
Practical 6. Modelling the different components of the screw jack.
Practical 7. Assembly of the different components of the screw jackPractical 8. Modelling the different components of the PLUMMER BLOCK
Practical 9. Assembly of the different components of the PLUMMER BLOCK.
Practical 10. Modelling the different components of the FLANGE COUPLING
Practical 11. Assembly of the different components of the FLANGE COUPLING.
Practical 12. Modelling the different components of the cam and follower.
Practical 13. Assembly of the different components of the cam and follower
Practical 14. Modelling the different components of the Oldham coupling
Practical 15. Assembly of the different components of the Oldham coupling
Practical 16. Modelling the different components of the slider crank mechanism
Practical 17. Assembly of the different components of the slider crank mechanism
Practical 18. Modelling the different components of the spur gear
Practical 19. Assembly of the different components of the gear train
Practical 20. Use of helical sweep command to construct springs
Practical 21. Use of revolve command to construct objects.
Practical 22. Modelling the different components of a fan
Practical 23. To create a bolt and nut assembly using creo
Practical 24. To make an impeller using creo
Practical 25. Simulation of cam follower arrangement.
Practical 26. Simulation of the slider crank mechanism
Practical 27. Simulation of the Oldham coupling mechanism
Practical 28. Simulation of the gear train.
Practical 29. Simulation of planetary gear train.
Practical 30. Mechanical analysis of beam in creo
Practical 31.Mechanical analysis of cam and follower movement
Practical 32. Direct modelling of chain drive and its sprockets
Practical 33. Simulation of chain drive and its sprockets
Practical 34. Modelling damper system of a mass spring damper system
Practical 35. Simulation of a mass spring damper system