Troubleshooting guide Dear Customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions thoroughly before connecting, operating or adjusting this product. Keep this manual for future reference. WARNING: To reduce the risk of fire, electric shock or product damage, • Do not expose this unit to rain, moisture, dripping or splashing. • Do not place objects filled with liquids, such as vases, on this unit. • Use only the recommended accessories. • Do not remove covers. • Do not repair this unit by yourself. Refer servicing to qualified service personnel. Product identification marking Location Product Bottom Main unit Bottom AC adaptor –If you see this symbol– Disposal of old Equipment and Batteries Only for European Union and countries with recycle systems The mains plug is the disconnecting device. Install this unit so that the mains plug can be unplugged from the socket outlet immediately. Operating Instructions Clock Radio Model No. RC-CF30GN-K Panasonic Corporation Web Site: http://www.panasonic.com En ADJ Z F CLOC RQT0A54-L Factory reset CAUTION! To reduce the risk of fire, electric shock or product damage, • Do not install or place this unit in a bookcase, built-in cabinet or in another confined space. Ensure this unit is well ventilated. • Do not obstruct this unit’s ventilation openings with newspapers, tablecloths, curtains, and similar items. • Do not place sources of naked flames, such as lighted candles, on this unit. CAUTION! This unit is intended for use in moderate climates. This unit may receive radio interference caused by mobile telephones during use. If such interference occurs, please increase separation between this unit and the mobile telephone. Factory reset Operating Instructions Clock Radio Model No. RC-CF30 Panasonic Corporation Web Site: http://www.panasonic.com En ADJ Z F CLOC RQT0A54-L Specifi• iPod nano 7th generation • iPod touch 5th generation • iPhone 5 • iPhone 5C • iPhone 5S • iPhone 6 • iPhone 6 Plus Compatibility depends on the software version of your iPod or iPhone. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. iPhone, iPod nano and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. Compatible iPod and iPhone Placement Set the unit up on an even surface away from direct sunlight, high temperatures, high humidity, and excessive vibration. These conditions can damage the cabinet and other components, thereby shortening the unit’s service life. Place it at least 15 cm away from wall surfaces to avoid distortion and unwanted acoustical effects. Do not place heavy items on the unit. Voltage Do not use high voltage power sources. This can overload the unit and cause a fire. Do not use a DC power source. Check the source carefully when setting the unit up on a ship or other places where DC is used. AC adaptor protection Ensure the AC adaptor is connected correctly and not damaged. Poor connection and lead damage can cause fire or electric shock. Do not pull, bend, or place heavy items on the lead. Grasp the plug firmly when unplugging the adaptor. Pulling the AC adaptor can cause electric shock. Do not handle the plug with wet hands. This can cause electric shock. Foreign matter Do not let metal objects fall inside the unit. This can cause electric shock or malfunction. Do not let liquids get into the unit. This can cause electric shock or malfunction. If this occurs, immediately disconnect the unit from the power supply and contact your dealer. Do not spray insecticides onto or into the unit. They contain flammable gases which can ignite if sprayed into the unit. Service Do not attempt to repair this unit by yourself. If sound is interrupted, indicators fail to light, smoke appears, or any other problem that is not covered in these instructions occurs, disconnect the AC adaptor and contact your dealer or an authorised service centre. Electric shock or damage to the unit can occur if the unit is repaired, disassembled or reconstructed by unqualified persons. Extend operating life by disconnecting the unit from the power source if it is not to be used for a long time. Safety precautions Please check and identify the supplied accessories. 1 AC adaptor For others (not supplied) 1 AM loop antenna Supplied accessories Troubleshooting guide The back-up battery (CR2032) saves the clock and alarm settings in the event of a power interruption. Bottom view 1 Keep the AC adaptor connected to the household mains socket when unscrewing the screw on the cover of the battery holder using a screwdriver. 2 Open the cover of the battery holder. 3 Insert a new battery with the (+) side facing up. 4 Close the cover of the battery holder and secure it with the screw. Replacing the battery The service life of this battery is approximately 1 month if AC power is down. When the battery is weak, the battery-weak indicator will blink constantly on the display. Note: • Do not heat or expose to flame. • Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period of time with doors and windows closed. • Remove the battery if the clock radio is not going to be used for a long period of time. Store in a cool, dark place. CAUTION • Danger of explosion if battery is incorrectly replaced. Replace only with the type recommended by the manufacturer. • When disposing of the batteries, please contact your local authorities or dealer and ask for the correct method of disposal. Warning Keep the Button-Type battery out of the reach of children. Never put Button- Type battery in mouth. If swallowed call your doctor. Insert with poles aligned. Do not touch the terminals ( + and - ) with metal objects. Warning Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100 C or incinerate. Memory backup Troubleshooting guide Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated do not solve the problem, consult your dealer for instructions. Clock Clock cannot be synchronised to iPod or iPhone’s time. • Make sure the iPod or iPhone is securely connected and turned on. • Update your iPod or iPhone with the latest software. Daylight saving time does not work. • Make sure the clock has been set correctly. • Press and hold [ ] in clock mode to activate daylight saving time. Alarm The iPod, radio or buzzer alarm does not sound at the preset time. • Check that “ALARM 1” or “ALARM 2” has been correctly activated. The iPod or radio alarm is activated but there is no sound at the preset time. • Check the alarm’s volume setting. iPod or iPhone The iPod or iPhone cannot be operated with this unit. • Make sure the iPod or iPhone has been securely connected and turned on. • Update your iPod or iPhone with the latest software. There is no sound from the iPod or iPhone. • Make sure the iPod or iPhone has been securely connected. • Adjust the volume. The iPod or iPhone does not charge. • Check the connections. Turn off and remove the iPod or iPhone from the dock connector. Reinsert and turn it on again. Radio A noise or sound distortion is heard. • Distance the unit away from any television, personal computer or device easily influenced by magnetism. A low hum is heard during AM broadcast. • Separate the antenna from other cables and cords. o SpecifiTroubleshooting guide AMPLIFIER SECTION RMS Output Power (Mono) 2.6 W (3 ), 1 KHz, 10% THD Front channel TUNER SECTION FM 10 stations AM 10 stations Preset memory Frequency modulation (FM) 87.50 MHz to 108.00 MHz (50 KHz step) Frequency range Antenna terminals 75 (unbalanced) Amplitude modulation (AM) Frequency range 522 kHz to 1629 kHz (9 kHz step) 520 kHz to 1630 kHz (10 kHz step) SPEAKER SECTION 1 way, 1 speaker system Type Impedance 3 Speaker unit(s) 40 mm cone type Full range GENERAL AC 100 to 240 V, 50/60 Hz Power supply (AC adaptor) 5 V DC Output Power consumption (with iPod or iPhone charging) 11 W Main unit 123 mm x 92 mm x 105 mm Dimension (W x H x D) Mass Main unit 0.357 Kg (approximate) AC adaptor 0.095 Kg (approximate) 0 C to + 35 C Operating temperature range 20% to 80% RH (no condensation) Operating humidity range Power consumption in standby mode: Main unit 0.3 W (approximate) AC adaptor 0.3 W (approximate) Note: 1) Specifications are subject to change without notice. Mass and dimensions are approximate. 2) Total harmonic distortion is measured by the digital spectrum analyser. o o 1. The product is warranted for 12 months from the date of purchase. Subject to the conditions of this warranty Panasonic or its Authorised Service Centre will perform necessary service on the product without charge for parts or labour, if in the opinion of Panasonic, the product is found to be faulty within the warranty period. 2. This warranty only applies to Panasonic products purchased in Australia and sold by Panasonic Australia or its Authorised Distributors or Dealers and only where the products are used and serviced within Australia or it's territories. Warranty cover only applies to service carried out by a Panasonic Authorised Service Centre and only if valid proof of purchase is presented when warranty service is requested. 3. This warranty only applies if the product has been installed and used in accordance with the manufacturer’s recommendations (as noted in the operating instructions) under normal use and reasonable care (in the opinion of Panasonic). The warranty covers normal domestic use only and does not cover damage, malfunction or failure resulting from use of incorrect voltages, incorrect installation, accident, misuse, neglect, build-up of dirt or dust, abuse, maladjustment of customer controls, mains supply problems, thunderstorm activity, infestation by insects or vermin, tampering or repair by unauthorised persons (including unauthorised alterations), introduction of sand, humidity or liquids, commercial use such as hotel, office, restaurant, or other business or rental use of the product, exposure to abnormally corrosive conditions or any foreign object or matter having entered the product. 5. Some products may be supplied with Ethernet connection hardware. The warranty is limited on such products and will not cover 6. To claim warranty service, when required, you should: 7. The warranties hereby conferred do not extend to, and exclude, any costs associated with the installation, de-installation or re-installation of a product, including costs related to the mounting, de-mounting or remounting of any screen, (and any other ancillary activities), delivery, handling, freighting, transportation or insurance of the product or any part thereof or replacement of and do not extend to, and exclude, any damage or loss occurring by reason of, during, associated with, or related to such installation, de-installation, re-installation or transit. Panasonic Authorised Service Centres are located in major metropolitan areas and most regional centres of Australia, however, coverage will vary dependant on product. For advice on exact Authorised Service Centre locations for your product, please telephone our Customer Care Centre on 132600 or visit our website and use the Service Centre Locator. In addition to your rights under this warranty, Panasonic products come with consumer guarantees that cannot be excluded under the Australian Consumer Law. If there is a major failure with the product, you can reject the product and elect to have a refund or to have the product replaced or if you wish you may elect to keep the goods and be compensated for the drop in value of the goods. You are also entitled to have the product repaired or replaced if the product fails to be of acceptable quality and the failure does not amount to a major failure. If there is a major failure in regard to the product which cannot be remedied then you must notify us within a reasonable period by contacting the Panasonic Customer Care Centre. If the failure in the product is not a major failure then Panasonic may choose to repair or replace the product and will do so in a reasonable period of time from receiving notice from you. If you require assistance regarding warranty conditions or any other enquiries, please visit the Panasonic Australia website www.panasonic.com.au or contact by phone on 132 600 If phoning in, please ensure you have your operating instructions available. (a) Internet and or DLNA connection / setup related problems (b) Access fees and or charges incurred for internet connection (c) The use of incompatible software or software not specifically stipulated in the product operations manual; and (d) Any indirect or consequential costs associated with the incorrect use or misuse of the hardware, its connection to the internet or any other device. 4. This warranty does not cover the following items unless the fault or defect existed at the time of purchase: s c s i D e l b a d r o c e R r o y a r - u l B , D V D ) e ( ) s ( t r a P t e n i b a C ) a ( (b) Video or Audio Tapes (f) Video / Audio Heads from wear and tear in normal use (c) SD cards or USB devices (g) Information stored on Hard Disk Drive, USB stick or SD card (d) User replaceable Batteries (h) DTV reception issues caused by TV Aerial / Cabling / Wall socket(s) etc Telephone Panasonic’s Customer Care Centre on 132600 or visit our website referred to below and use the Service Centre Locator for the name/address of the nearest Authorised Service Centre. Send or take the product to a Panasonic Authorised Service Centre together with your proof of purchase receipt as a proof of purchase date. Please note that freight and insurance to and / or from your nearest Authorised Service Centre must be arranged by you. Note that home or pick-up/delivery service is available for the following products in the major metropolitan areas of Australia or the normal operating areas of the nearest Authorised Service Centres: Plasma/LCD televisions / displays (screen size greater than 103 cm) THIS WARRANTY CARD AND THE PURCHASE DOCKET (OR SIMILAR PROOF OF PURCHASE) SHOULD BE RETAINED BY THE CUSTOMER AT ALL TIMES Panasonic Australia Pty. Limited ACN 001 592 187 ABN 83 001 592 187 1 Innovation Road, Macquarie Park NSW 2113 PRO-031-F11 Issue: 4.0 01-01-2011 Specifications Panasonic Warranty Memory backup In standby mode, press [ ] and [VOL ], “dEF” will show on LCD. Factory reset is done. Limited Warranty (FOR AUSTRALIA ONLY) 1 CR2032 Lithium button-type backup battery (Battery is already installed in the unit.) Lightning is a trademark of Apple Inc.. GN Before using the first time Remove the insulation sheet . Inserting the battery When there is no battery, the battery weak indicator will be displayed until a battery is inserted. Compatibility depends on the software version. Update your iPhone / iPod to the latest software before using it with this unit. Please be aware that Panasonic accepts no responsibility for the loss of data and / or information. These symbols are only valid in the European Union and countries with recycle systems. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.