Chapter 7 Circle Gauge Tool Synopsis This chapter will guide you through how to setup a VPM program to inspect a AA battery before it is capped and sealed. The Circle Gauge Tool can be used as a locate or as an inspection tool.
Dec 28, 2015
Chapter 7
Circle Gauge Tool
Synopsis
This chapter will guide you through how to setup a VPM program to inspect a AA battery before it is capped and sealed. The Circle Gauge Tool can be used as a locate or as an inspection tool.
1-Launch VPM
2-Connect to the emulator or live camera (Refer to chapter 1--A)
3-Load the Indicator images into the File Camera (Refer to chapter 1--B) The file names are 01_Indicator_Pass, 02_Indicator_Fail, etc.
4-Click on the orange IMPACT icon.
1-Click on Create New Vision Program. Notice the icon that is orange.
2-Click New Program.
1-Name the program Indicator.vp
1-Open the Measurement tool drawer by clicking on it.
2-Drag and drop the Circle Gauge Find Tool into the program tree.
3-Be sure to start with the best Image.
1-Click step 2
2-Setup as shown
1-Click on Step 3
2-Scroll through images and note pass/fail results
3-These are the default settings.
In this case the battery passes and fails correctly.
1-Add Pass/Fail Tool
2-Add and configure Discrete I/O Tools
3-Scroll through images