Chapter 11 Elasticity And Periodic Motion. Stress characterizes the strength of the force associated with the stretch, squeeze, or twist, usually on.

Chapter 11Elasticity And Periodic Motion

Stress characterizes the strength of the force associated with the stretch, squeeze, or twist, usually on a “force per unit area” basis.

Strain describes the deformation that occurs.

When the stress and strain are small enough, we often find that the two are directly proportional. The general pattern that emerges can be formulated as Stress/Strain = Constant.

Experiments have shown that, for a sufficiently small tensile or compressive stress, stress and strain are proportional, as stated by Hooke’s law. The corresponding proportionality constant, called Young’s modulus (denoted by Y ), is given by

Y = (Tensile stress)/(Tensile strain) or

Y = (Compressive stress)/(Compressive strain),

Or

Y = (F /A) / (Δl / l0)

• Strain is a pure number, so the units of Young’s modulus are the same as those of stress: force per unit area.

• Young’s modulus is a property of a specific material, rather than of any particular object made of that material.

• A material with a large value of Y is relatively un-stretchable; a large stress is required by a given strain.

Modeling an Elastic Material as a Spring

Fperpendicular = (YA Δl) / l0

Let k = (YA) / l0 , Δl = x and Fperpendicular = Fx ; then we have Fx = kx.

The pressure in a fluid, denoted by p, is the force Fperpendicular per unit area A transmitted across any cross section of the fluid, against a wall of its container, or against a surface of an immersed object:

p = Fperpendicular/A

When a solid object is immersed in a fluid and both are at rest, the forces that the fluid exerts on the surface of the object are always perpendicular to the surface at each point.

When Hooke’s law is obeyed, the volume strain is proportional to the volume stress (change in pressure). The corresponding constant ratio of stress to strain is called the bulk modulus, denoted by B.

When the pressure on an object changes by a small amount Δp, from p0 to p0 + Δp, and the resulting volume strain is ΔV/V, Hooke’s law takes the form

B = - (Δp)/(ΔV/V0)

We include a minus sign in this equation because an increase in pressure always causes a decrease in volume. In other words, when Δp is positive, ΔV is negative.

Shear Stress and Strain

If the forces are small enough so that Hooke’s law is obeyed, the shear strain is proportional to the shear stress. The corresponding proportionality constant (ratio of shear stress to shear strain), is called the shear modulus, denoted by S:

S = Shear stress / Shear strain

= (Fparallel / A) / (x / h)

= (Fparallel / A) / Φ

Periodic Motion

Fx = -kxUsing Newton’s second law,

max = -kx OR

ax = -(k/m)x

• Amplitude, A

• Cycle

• Period, T

• Frequency, f f = 1/T SI unit : Hertz (Hz) = cycle/s = 1/s

• Angular frequency, ω ω = 2πf = 2π/T

Conservation of Mechanical EnergyE = (1/2) mvx

2 + (1/2)kx2 = constant

Energy in Simple Harmonic Motion

When x = ± A, vx = 0. At this point, the energy is entirely potential energy and E = (1/2)kA2 .

E = (1/2)kA2 = (1/2) mvx2 + (1/2)kx2

vx = ± k/m A2 – x2

We can use this equation to find the magnitude of the velocity for any given position x.

A useful equation

Equations of Simple Harmonic Motion

Periodic Motion

The relationship between uniform

circular motion and simple harmonic

motion.

x = A cos θ x = A cos(ωt) x = A cos [(2π/T )t]SI unit: m

Position of the Shadow as a Function of Time

Velocity in Simple Harmonic Motion

v = -Aω sin(ωt)SI unit: m/s

Maximum speed of the mass is vmax = Aω

T = 2π m / kSI unit: s

Period of a Mass on a Spring

From equation ax = -Aω2 cos(ωt)ax = -Aω2 (maximum acceleration) (1)Also, we know that ax = -(kx)/m ax = -(kA)/m (maximum acceleration) (2)From equations (1) and (2)-Aω2 = -kx/mω2 = k/mω = k/m = 2πf = 2π/T

The Simple Pendulum

The restoring force F at each point is the component of force tangent to the circular path at that point:

F = -mgsinθ

If the angle is small, sinθ is very nearly equal to θ (in radians).

F = -mgθ = -mgx/LF = -(mg/L)x

The restoring force F is then proportional to the coordinate x for small displacements, and the constant mg/L represents the force constant k.

K=mg/L

NOTE that the frequency does NOT dependon the mass but on the length of the pendulum

A 0.85-kg mass attached to a vertical spring of force constant 150 N/m oscillates with a maximum speed of 0.35 m / s. Find the following quantities related to the motion of the mass: (a) the period, (b) the amplitude, (c) the maximum magnitude of the acceleration.

A peg on a turntable moves with a constant linear speed of 0.67 m / s in a circle of radius 0.45 m. The peg casts a shadow on a wall. Find the following quantities related to the motion of the shadow: (a) the period, (b) the amplitude, (c) the maximum speed, and the maximum magnitude of acceleration.

Ch. 11, Problem 42.

An object of unknown mass is attached to an ideal spring with force constant 120 N/m and is found to vibrate with frequency of 6.00 Hz. Find

(a) period, (b) the angular frequency, and (c) the mass of this object.

(a)If a pendulum has period T and you double its

length, what is its new period in terms of T?

(b)If a pendulum has length L and you want to triple its frequency, what should be its length in terms of L?

(c)Suppose a pendulum has a length L and period T on earth. If you take it to a planet where the acceleration of freely falling objects is ten times what it is on earth, what should you do to the length to keep the period the same as on earth?

Ch. 11, Problem 49

(d) If you do not change the pendulum’s length in part (c ), what is its period on that planet in terms of T?

(e) If a pendulum has a period T and you triple the mass of its bob, what happens to the period (in terms of T)?

CHAPTER 11, PROBLEM 24

Find the period, frequency, and angular frequency of (a) the second hand and (b) the minute hand of a wall clock.

CHAPTER 11, Problem 47

A certain simple pendulum has a period on earth of 1.60 s. What is the period on the surface on Mars, where the acceleration due to gravity is 3.71 m/s2 ?

Chapter 11, Problem 33

A mass is oscillating with amplitude A at the end of a spring. How far (in terms of A) is this mass from equilibrium position of the spring when the elastic potential energy equals the kinetic energy?


(a)If a vibrating system has total energy E0, what will its total energy be (in terms of E0) if you double the amplitude of vibration?

(b)If you want to triple the total energy of a vibrating system with amplitude A0, what should its new amplitude be (in terms of A0)?


An object suspended from a spring vibrates with simple harmonic motion. At an instant when the displacement of the object is equal to one-half the amplitude, what fraction of the total energy of the system is kinetic and what fraction is potential?

After you pick up a spare, your bowling ball rolls without slipping back toward the ball rack with a linear speed of 2.85 m/s. To reach the rack, the ball rolls up a ramp that rises through a vertical distance of 0.53 m. (a) What is the linear speed of the ball when it reaches the top of the ramp? (b) If the radius of the ball were increased, would the speed found in part (a) increase, decrease, or stay the same? Explain.

CHAPTER 12MECHANICAL WAVES AND SOUND

A disturbance that propagates from one place to another is referred to as a wave.

Waves propagate with well-defined speeds determined by the properties of the material through which they travel.

Waves carry energy.

In a transverse wave individual particles move at right angles to the direction of wave propagation.

In a longitudinal wave individual particles move in the same direction as the wave propagation.

A wave on a string

As a wave on a string moves

horizontally, all points on the

string vibrate in the vertical direction.

Water waves from a disturbance.

The water wave has characteristics of both

transverse and longitudinal waves.

Wavelength, Frequency, and

Speed

Sound produced by a speaker

REFLECTIONS AND SUPERPOSITION

A reflected wave pulse: fixed end

A reflected wave pulse: free end

Sound Waves

Speed of Sound in Air

v = 343 m/s

The frequency of sound determines its pitch. High-pitched sounds have high frequencies; low-pitched sounds have

low frequencies.

Human hearing extends from 20 Hz to 20, 000 Hz. Sounds with frequencies above this range are referred to as

ultrasonic, while those with frequencies lower than 20 Hz are classified as

infrasonic.

Constructive Interference

Destructive Interference

Figure 14-22Interference with Two Sources

In phase/opposite phase: Two sources are in phase if they both emit crests at the same time. Sources have opposite phase if one emits a crest at the same time other emits a trough.

Constructive interference occurs when the path length from the two sources differs by 0, λ, 2λ, 3λ, …….

Destructive interference occurs when the path length from the two sources differs by λ/2, 3λ/2, 5λ/2, …….

The loudness of a sound is

determined by its intensity; that is; by the amount of

energy that passes through a given area in a given

time.I = E/(At)

OrI = P/A

I1 = P/(4πr12)

I2 = P/(4πr22)


A cart carrying a vertical missile launcher moves horizontally at a constant velocity of 30.0 m/s to the right. It launches a rocket vertically upward. The missile has an initial vertical velocity of 40.0 m/s relative to the cart.

(a) How high does the rocket go? (b) How far does the cart travel while the rocket is in air? (c) Where does the rocket land relative to the cart?


Your spaceship lands on an unknown planet. To determine the local value of g, you ask a steel-toed crew member to kick a stone, and you find that if she kicks it at 17.6 m/s at various angles, the maximum range she can achieve is 33.8 m.

(a) What is g on this planet?

(b) How long was the stone in the air?

(c) How high above the ground did the stone go?

Chapter 3 Problem 55

A baseball thrown at an angle of 60.0° above the horizontal strikes a building 18.0 m away at a point 8.00 m above the point from which it was thrown. Ignore air resistance.

(a) Find the magnitude of the initial velocity of the baseball (the velocity with which the baseball

is thrown).

(b) Find the magnitude and direction of the velocity

of the baseball just before it strikes the building.


A 2.00 kg frictionless block is attached to an ideal spring with force constant 315 N/m. Initially the spring is neither stretched nor compressed, but the block is moving in the negative direction at 12.0 m/s. Find

(a)the amplitude of the motion,

(b) the maximum acceleration of the block, and

(c) the maximum force the spring exerts on the block.


Repeat the previous problem, but assume that initially the block has velocity -4.00 m/s and displacement +0.200 m.


A tuning fork has the tip of each of its two prongs vibrating in simple harmonic motion with a frequency of 392 Hz and an amplitude of 0.600 mm, while a housefly with mass 0.0270 g is holding onto the tip of one of the prongs. What are

(a) the maximum speed of the tip of a prong and

(b) the fly’s maximum kinetic energy?

Chapter 11 Elasticity And Periodic Motion. Stress characterizes the strength of the force associated with the stretch, squeeze, or twist, usually on.

Documents