This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
BASIC SIGNAL• The radar signal scatters efficiently off the waves when the wavelengths
are exactly half the transmitted signal wavelength (3-50m) AND the waves are traveling in a radial path either directly away from or towards the radar.
• The scattered radar waves add coherently (Bragg scattering) resulting in a strong return of energy at a very precise wavelength.
• At the CODAR SeaSonde's frequencies (4-50 MHz), the periods of these Bragg scattering short ocean waves are between 1.5 and 5 seconds. (Such waves are almost always present.)
25 MHz transmission 12m EM wave 6m ocean wave12 MHz transmission 25m EM wave 12.5m ocean wave
5 MHz transmission 60m EM wave 30m ocean wave
4. The wave speed is known from the deep water dispersion relation.Thus, the wavelength, direction and wave speed
DOPPLER SIGNAL1. The returning signal exhibits a Doppler-frequency shift. 2. In the absence of ocean currents, the Doppler frequency
shift would always arrive at a known position in the frequency spectrum based on the wave velocity.
3. The difference between the observed Doppler shift and the shift due to the theoretical speed wave speed is the radial component of the underlying ocean current.
4. The current influencing the Bragg waves falls within the upper meter of the water column (or upper 2.5 meters when transmitting between 4-6 MHz).
5. With 2 radar stations, a surface velocity vector field can be derived.
When the first satellite passes over a region of slightly stronger gravity, a gravity anomaly, it is pulled slightly ahead of the trailing satellite. The following spacecraft accelerates, then decelerates over the same point. By measuring the constantly changing distance between the two satellites and combining that data with precise positioning measurements one may construct a detailed map of Earth's gravity anomalies.
"gravity anomaly" maps show where models of the Earth's gravity field based on GRACE data differ from a simplified mathematical model that assumes the Earth is perfectly smooth and featureless.
Change in gravity:simulated water storage retrievals from GRACE (blue line) match up with actual hydrological model data (gray line) for an aquifer in northern Kansas, southern Nebraska, and eastern Colorado (area shown in blue on map inset).
Three pairs of ultra-sensitive accelerometers arranged to responded to tiny variations in the three-dimensional 'gravitational tug' of the Earth as it travelled along its orbital path. Because of their different position in the gravitational field they all experienced the gravitational acceleration of the Earth slightly differently.
Laser FluorosensingVegetation fluorescence: species dependence.
Takahasi K., et al. (1993) Laser induced fluorescence of tree leaves: spectral changes with plant species and seasonsProceedings of IGARSS '93 - IEEE International Geoscience and Remote Sensing Symposium, pp: 1985-1987 Doi: 10.1109/IGARSS.1993.322367
Figure 2: Excitation-emission spectra for natural organic matter to be used as a typing rapid screening method for identifying potential of organic matter for interactions with water treatment chemicals and transport of contaminants
Fluorescence spectra of different oil types with excitation at 308 nm. The curves are normalized to the same total fluorescence in order to highlight the shape of the spectra. The absolute fluorescence intensity of heavy oils is much weaker than that of light oils and could not be visualized on the graph without normalization.
Fluorescence emission from a pure water sample from the North Sea.
water
Raman scattering of purified (i.e., non-fluorescent) water with the 308 nm fluorescence lidar. The Raman intensity decreases with increasing thickness of an oil film on the water surface. At the same time, fluorescence of the oil increases.
Individual multispectral scanner images were geometrically and radiometrically corrected and calibrated with respect to oil film thickness by using the laser fluorosensor data.
Fraunhofer Line Descriminator• Makes use of the Fraunhofer lines in the solar spectrum
– Fraunhofer lines are the absorption lines in the solar spectrum– No radiation reaches the earth in these narrow (~0.1 nm) bands– Any radiation sensed in these bands is produced (emitted) by the target
(fluorescence, Raman scattering, etc.)
Observations are made within a Fraunhofer line in a region where fluorescence would be expected from a particular molecule.
Chlorophyll fluorescence (~685 nm, ~730 nm)
Fraunhofer Line DescriminatorJoiner et al. (2011) First observations of global and seasonal terrestrial chlorophyll fluorescence from space. Biogeosciences, 8, 637-651
"Fluorescence estimated from high-spectral resolution data from the Thermal And Near-infrared Sensor for carbon Observation – Fourier Transform Spectrometer (TANSO-FTS) on the Japanese Greenhouse gases Observing SATellite (GOSAT). We use filling-in of the potassium (K) I solar Fraunhofer line near 770 nm to derive chlorophyll fluorescence and related parameters such as the fluorescence yield at that wavelength."
PAR = Photosynthetically Active Radiation is radiation from 400-700nm that is available to plants in photosynthesis.
fPAR = the fraction of PAR that is used by plants.
Left: human tooth. Centre: Image of the tooth demonstrating THz absorption reveals cavities in red. Right: time of flight THz data shows enamel and dentine, which have different refraction indices. http://www.frascati.enea.it/THz-BRIDGE/descr_gen2.htm
Oesophagus cancer from a horse.left: visible image; middle: THz-image recorded at 16 cm-1
(480 GHz) in the far field; right: image recorded with a solid immersion lens (SIL). The circles mark the metastasis, which can be very clearly identified as dark regionshttp://www.pi1.uni-stuttgart.de/research/Methoden/THzMikroSpektrometer_e.php
Transmission imaging of water diffusion into concrete through a crack.The strong absorption of THz radiation by water is one of the disadvantages for long-range propagation, however, it is an advantage for highly sensitive detection of water diffusion. The figure shows the sub-THz imaging of cracks in concrete, in which the supplied water diffuses along the cracks and then the diffused water enhances the detection sensitivity of cracks.
Terahertz imaging: industrial inspection
Top surface External pins = 1mm depth
Transistor = 3mm depth Pads on bottom surface = 4mm
3D images of different layers at different depths within an integrated circuit device.
• Typically rated in photometric units• foot-candle: the light intensity from a candle at a distance of one foot.
• lux: A unit of illumination equal to the illumination of a surface all of which is one metrefrom a uniform point source of light of unit intensity (one candela = one lumen per square meter).
Low Light Level Cameras
Daylight Range Foot-candles Lux
SunlightFull DaylightOvercast DayVery Dark DayTwilightDeep Twilight
10,0001,000100101.1
107,52710,752.71,075.3107.5310.751.08
Low Light Level Range
Full MoonQuarter MoonStarlightOvercast Night
.01
.001
.0001
.00001
.108
.0108
.0011
.0001
Standard techniques to increase the light collecting capacity:• large pixels• long integration times• cooled to reduce dark noise
Peltier coolers are so called because they take advantage of the Peltier Effect. The Peltier Effect was discovered in 1834 by a French watchmaker and physicist by the name of Jean Charles Athanase Peltier. The Peltier Effect takes place when an electrical current is sent through two dissimilar materials that have been connected to one another at two junctions. One junction between the two materials is made to become warm while the other becomes cool, in what amounts to an electrically-driven transfer of heat from one side of the device to the other. This transfer can be so dramatic as to bring the cool side below freezing.
Low Light Level Cameras
Techniques to increase the light collecting capacity (cont'd):
•Back illuminated, thinned CCDsThe CCDs are mounted with the back side toward the light. The silicon is reduced in thickness (thinned) to allow incoming photons to easily reach the imaging portion of the CCD. This technique provides very high quantum efficiency over a wide spectral range.
Low Light Level Cameras
Low Light Level Cameras• Image intensifier tubes
• Photons from a low-light source enter the objective lens (on the left) and strike the photocathode (gray plate).
• The photocathode (which is negatively biased) releases electrons which are accelerated to the higher-voltage microchannel plate (red). Each electron causes multiple electrons to be released from the microchannel plate.
• The electrons are drawn to the higher-voltage phosphor screen (green). Electrons that strike the phosphor screen cause the phosphor to produce photons of light amplified many times.
The EBCCD sensor has a transparent glass window through which photons are focused onto a semiconductor photocathode. Photons striking the photocathode generate electrons which are emitted into a vacuum cavity. The electrons are then electrically accelerated into a CCD array that outputs a high resolution, low noise video signal. Gain is achieved through the electron bombarded semiconductor in silicon.
Low Light Level Cameras• Examples of Low light-level cameras:
Single-beam side-scan sonarSide scan sonar uses narrow beams of acoustic energy transmitted out
to the side of the towfish and across the bottom.
Sound is reflected back from the bottom and from objects to the towfish.
Hard objects reflect more energy producing a strong signal, soft objects that do not reflect acoustic energy as well show up as lower (darker) signals.
1. Depth to inside of acoustic path.2. Vertical beam angle.3. Range setting in software (maximum
acoustic range).4. Swath width across seafloor.5. Tow depth of side scan sonar.6. Port and starboard channel separation.7. Horizontal beam width.http://www.starfishsonar.com/technology/sidescan-sonar.htm