CCNA 640-802 Three simulations were VTP, ACL and EIGRP (From 9tut.com) Note: These are 40 Questions + 3 Sims (43). I am not able to remember the other 10 Questions. There was a twisted question in VTP simulation as follows, The VTP was last updated by 192.168.1.250 but the IP addresses of the 2 neighboring switches were 192.168.1.247 and 192.168.1.249. So the 3 rd Switch in the network which is not adjacent to Sw-AC3 should have updated the VTP. ********************************************************************** *********** Other questions not in Dumps: 1. Which command will change the VTP domain name to null after you restart the switch? Ans: Erase vlan.dat 2. What are the 2 states are the RSTP states when the network has converged? Ans: Fordwarding and Disabled. 3. Which Cisco IOS diagnostic command can disrupt the operation of a router under high load conditions? Ans: Debug all 4. Which options are based on the standard access lists? Ans: Source Address and Wilcard mask 5. What is the IPV6 multicast address used by RIPng routing protocol? Ans: FF02::9