Casting Processes Chapters 10 -12 - University of Iowauser.engineering.uiowa.edu/~mie032/Lectures/15-Casting_Permanent... · Casting Processes Chapters 10 -12 Casting Processes Chapters

© R. Jerz 1 3/27/2006

Casting ProcessesChapters 10 -12

Casting ProcessesChapters 10 -12

© R. Jerz 2 3/27/2006

Process Equipment and CostProcess Equipment and Cost

FoundryFurnaces• (previous video – Ludken)

© R. Jerz 3 3/27/2006

Types of Melting FurnacesTypes of Melting Furnaces

Figure 11.26 Two types of melting furnaces used in foundries: (a) crucible, and (b) cupola.

© R. Jerz 4 3/27/2006

Process OverviewProcess Overview

Produce part in single step (“near-net”shape)Can produce a wide variety of shapes and sizesComplex shapes are possibleInternal cavities are possible

© R. Jerz 5 3/27/2006

Six Basic FactorsSix Basic Factors

1. Mold cavity2. Melting process3. Pouring technique4. Solidification process5. Removal of casting6. Cleaning/finishing

© R. Jerz 6 3/27/2006

Permanent Mold CastingPermanent Mold Casting

Die casting

© R. Jerz 7 3/27/2006

Typical Cast PartsTypical Cast Parts

(a)

(c)

(d)

© R. Jerz 8 3/27/2006

Die-Casting AlloysDie-Casting Alloys

© R. Jerz 9 3/27/2006

Die-Casting DiesDie-Casting Dies

Figure 11.19 Various types of cavities in a die-casting die. Source: Courtesy of American Die Casting Institute.

© R. Jerz 10 3/27/2006

Cleaning & FinishingCleaning & Finishing

Remove coresRemove gates and risersRemove fins, flashClean the surfaceRepair defects.Tumbling machines

© R. Jerz 11 3/27/2006

Defects Defects

Metal projectsCavitiesDiscontinuitiesDefective surfaceIncomplete castingIncorrect dimensions or shapeInclusions (unwanted material)Porosity• Shrinkage/gas

© R. Jerz 12 3/27/2006

General Casting Design RulesGeneral Casting Design RulesDesign the part to cast easily.Select the correct casting processLocate the parting line carefullyLocate and design the gates, runners, sprues, screens and risersCheck for proper controls and good practices

© R. Jerz 13 3/27/2006

Design for CastingDesign for Casting

Avoid sharp cornersAvoid thin sectionsPlan for shrinkage effectsUse draftAllow material for machining