C C A A S S H H C C O O D D E E B B I I L L L L A A C C C C E E P P T T O O R R SUB-ASSEMBLY 24-000198-00 14 Apr 2010 FOR INTERNAL USE ONLY 1 of 2 This document contains confidential information that is proprietary to Aristocrat. It may not be copied or disclosed to unauthorized parties. © 2010 Aristocrat Technologies Australia Pty Limited. All rights reserved. ►STEP 1 MOUNT CONNECTOR A A . . Use the existing nut to secure the Ground Cable (part of Interface Cable) to the RIGHT stud on the BA Housing as shown. B B . . Use the provided screws to secure the Interface Cable Connector to the back of the Housing. ►STEP 2 INSTALL BEZEL A A . . Open the top cover and slide the Bezel onto the front of the Bill Head. B B . . Place the Bezel Ground Cable on top of one of the mounting holes, and use the provided screws and washers (circled below) to secure the Bezel to the Bill Head C C . . Plug the Bezel Ribbon Cable into the front of the Bill Head as shown. ►STEP 3 INSTALL BILL HEAD A A . . Slide the Bill Head onto the Housing, ensuring it fully engages with the Interface Cable Connector. See reverse side for the parts, hardware, and tools required for this procedure.