8/16/2019 Car Weer manufactoring
1/17
CAR WHEELBY ZAHER NAIM ALMOFTY
SUBMITTED TO DR SADIQ ABDELALL
8/16/2019 Car Weer manufactoring
2/17
ALLOY WHEEL
Why it made from Aluminum?
1. it’
s more attractive than other metals2. Fraction of the wait, so less energy to rotate it with les fuel
3. Better control ,handling and acceleration
4
8/16/2019 Car Weer manufactoring
3/17
Manufacturing begins with high-grade aluminum alloy
• Containing ninety-seven percent aluminum a furnace
• Heat the furnace to 750 degrees Celsius• They liquefy in 25 min in the furnace
• Then Aluminum pour into mixer with argon gas is inject in toremove the hydrogen so increase its density and less porous
• Adding powder titanium to further strength the alloy• Then a flux is appeared so it must be remove
8/16/2019 Car Weer manufactoring
4/17
8/16/2019 Car Weer manufactoring
5/17
8/16/2019 Car Weer manufactoring
6/17
8/16/2019 Car Weer manufactoring
7/17
The wheel mold is made of high-strength steel
It consist of 3 parts
1. The upper which form the inside face
2. Four parts make the wheel edge
3. Lower mold which made the other face
,it is the intricate mold
8/16/2019 Car Weer manufactoring
8/17
• This machine is design to fill the mold from the bottom by pressuredinjection
• The injection is from the bottom to reduce the
air bubbles and defects parts
8/16/2019 Car Weer manufactoring
9/17
8/16/2019 Car Weer manufactoring
10/17
AFTER 7 MIN
8/16/2019 Car Weer manufactoring
11/17
8/16/2019 Car Weer manufactoring
12/17
Heat treatment
The casting then goes complex heat treatment
They heat the casting to 500c
Quenching which submerge the casting in water
For 30 sec
Then reheat the wheel to 100c for 9hours
And so on
8/16/2019 Car Weer manufactoring
13/17
MACHINING
The rough edges shown is trimmed
The wheel goes CNC lathe machine which remove the edges
And making finishing
8/16/2019 Car Weer manufactoring
14/17
8/16/2019 Car Weer manufactoring
15/17
INSPECTION
Then they submerge the wheel in water to
If any air bubbles appear this mean defect part because shrinkage takeplace
8/16/2019 Car Weer manufactoring
16/17
8/16/2019 Car Weer manufactoring
17/17
THANK YOU