ELOCONE NUTS Elocones are special elongated nuts that can be used to correct problems encountered when the anchor rods are installed without enough projection above the concrete foundation. These nuts are fabricated by machining a piece of high strength steel to two different sections. The upper section is similar to a standard nut and will bear on the column base or washer plate. The lower section has a smaller smooth diameter and is able to fit an oversized hole of the base plate to screw on enough threads of the anchor rod installed with a short projection. In order to develop the tension capacity of an anchor made of steel with a tensile strength of 150 ksi (1,035 MPa), the Elocone nuts must be fastened to the anchor rod for a length equal to the diameter of the rod.
2
Embed
Canam - Elocone Nuts · Elocone nuts are machined pieces with a standard nut head and an elongated lower part that can be screwed to anchor rods within the thickness of the base plate.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
ELOCONENUTSElocones are special elongated nuts that can be used to correct problems encountered when the anchor rods are installed without enough projection above the concrete foundation.
These nuts are fabricated by machining a piece of high strength steel to two different sections. The upper section is similar to a standard nut and will bear on the column base or washer plate. The lower section has a smaller smooth diameter and is able to fit an oversized hole of the base plate to screw on enough threads of the anchor rod installed with a short projection.In order to develop the tension capacity of an anchor made of steel with a tensile strength of 150 ksi (1,035 MPa), the Elocone nuts must be fastened to the anchor rod for a length equal to the diameter of the rod.
To get more information or to order Elocone nuts, please contact us.
A
A
SECTION A-A
A
E EG D
B
F
C
Elocone nuts are machined pieces with a standard nut head and an elongated lower part that can be screwed to anchor rods within the thickness of the base plate. Dimensions can change without notice. Elocones nuts can be produced with hot-dip galvanized finish on demand. In addition, the washers for Elocone nuts are sold separately.