Can tilt tests provide correct Can tilt tests provide correct insight regarding frictional insight regarding frictional behavior of sandstone under behavior of sandstone under seismic excitation? seismic excitation? Y.M. Hsieh, Y.M. Hsieh, K. C. Lee* K. C. Lee* , F.S. Jeng and , F.S. Jeng and T.H. Huang T.H. Huang National Taiwan University National Taiwan University National Taiwan University of Science and Technology National Taiwan University of Science and Technology September 22, 2009 September 22, 2009 An International Conference in Commemoration of the 10th Anniversary of the Chi-Chi Earthquake
18
Embed
Can tilt tests provide correct insight regarding frictional behavior of sandstone under seismic excitation? Can tilt tests provide correct insight regarding.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Can tilt tests provide correct insight Can tilt tests provide correct insight regarding frictional behavior of sandstone regarding frictional behavior of sandstone
under seismic excitation?under seismic excitation?
Y.M. Hsieh, Y.M. Hsieh, K. C. Lee*K. C. Lee*, F.S. Jeng and T.H. Huang, F.S. Jeng and T.H. HuangNational Taiwan UniversityNational Taiwan University
National Taiwan University of Science and TechnologyNational Taiwan University of Science and Technology
September 22, 2009September 22, 2009An International Conference in Commemoration of the 10th Anniversary
of the Chi-Chi Earthquake
OutlinesOutlines Introduction Purposes Methodology Differences on μt and μc
Factors affecting μc
Observed μi(t) after initiation of sliding
Effect of excitation frequency on μi(t)
Discussion Conclusion
2
3
IntroductionIntroduction (1/2) (1/2)
(Chen, 1999 )
Wedge failureWedge failure
(Lee, 2004 )
• Friction angle or friction coefficient obtained from tilt test is questionable when applied to dynamic problems.
• For slope stability analyses considering only the gravity effect, tilt test is a convenient and reasonable test method for measuring friction coefficient or friction angle.
4
IntroductionIntroduction (2/2) (2/2)
the applicability of tilt test measured friction coefficients on determining the sliding threshold of earthquake-induced block slides is discussed.
The discussion is facilitated by comparing the sliding thresholds obtained from measured using the proposed small-scale
laboratory tests versus calculated using tilt test measured friction
coefficient.
5
Purposes
Methodology (1/3)Methodology (1/3)
• Tilt test μt (Barton and Choubey (1977) )
• Shaking table test
6
•Uniaxial accelerometers at A1, A2, A3 positions•High precision laser displacement sensors at L1 and L2 positions
Affects of normal stressesAffects of normal stresses
4Hz 6Hz 8Hz
3. Observed 3. Observed μμii(t)(t) after initiation of sliding after initiation of sliding (1/2) (1/2)
12(Olsson et al, 1998)
Point Aμc=0.25
3. Observed 3. Observed μμii(t)(t) after initiation of sliding after initiation of sliding (2/2) (2/2)
13(Olsson et al, 1998)
3. Effect of excitation frequency on 3. Effect of excitation frequency on μμii(t)(t)
14
-1.0
-0.5
0.0
0.5
1.0
-20 -10 0 10 20 30 40 50
Vr (mm/sec)
μi(Vr)
4Hz_synthetic sandstone6Hz_synthetic sandstone
-1.0
-0.5
0.0
0.5
1.0
-2 0 2 4 6 8 10
s (mm)
μi(s)
4Hz_synthetic sandstone6Hz_synthetic sandstone
Discussion Discussion (1/2)(1/2)
15
under static conditionunder static condition under seismic excitation conditionunder seismic excitation condition
Discussion Discussion (2/2)(2/2)
16
ConclusionConclusion
• The sliding threshold should be measured using dynamic tests such as shaking table tests used in this study.
• During excitation, the inertial forces of the sliding block cause non-uniformity of normal stresses, and indirectly cause reductions to friction coefficients, thus, larger displacements.
• In order to establish rock block or rock slope sliding models during excitation, it is necessary to use frictional model based measured behaviors on real rock materials or synthetic rock materials.
17
Thanks for your attentionsThanks for your attentions