CADILLAC OF SEAWALLS 3 (Read-Only)

THE CADILLAC OF SEAWALLS

CONSTRUCTION OF AN ALL CONCRETE SEAWALL

IN FRONT OF AN EXISTING SEAWALL

THE FOLLOWING PHOTOS ARE OF A CONCRETE SEAWALL BEING

INSTALLED IN FRONT OF AN EXISTING SEAWALL.

THIS TYPE OF SEAWALL CAN BE INSTALLED WHERE THERE ARE

EXISTING STRUCTURES SO LONG AS THERE IS AT LEAST AN 8

FOOT WIDE ACCESS FROM THE STREET TO THE SEAWALL AND AN

OPEN AREA BEHIND THE SEAWALL TO ALLOW THE EQUIPMENT

TO MOVE FROM ONE END OF THE SEAWALL TO THE OTHER.

INSTALLING SLABS IN FRONT OF THE EXISTING SEAWALL

SMALLER EQUIPMENT IS

AVAILABLE WHEN THERE IS LESS

AREA TO WORK IN

INSTALLING SLABS CONTINUED

SLABS ADJOINING COMPLETED SEAWALL

THE NEW SEAWALL CAN BE INSTALLED HIGHER

THAN THE EXISTING OR THE SAME ELEVATION

THE NEW CONCRETE SLABS ARE

JETTED INTO PLACE USING A

WATER PUMP

SLAB INSTALLATION COMPLETE

SEAWALL CAP FORMED AND READY FOR CONCRETE

FORMS ARE INSTALLED OVER THE

EXISTING AND NEW SEAWALL SLABS

CONCRETE SHALL BE PUMPED

BETWEEN THE OLD AND NEW

SEAWALL

SEAWALL COMPLETE AND READY FOR FILL AND SOD

SEAWALL COMPLETE AND READY FOR FILL AND SOD

SEAWALL COMPLETE AND READY FOR FILL AND SOD

SEAWALL COMPLETE READY FOR SOD

IN MOST CASES THE IMPACT ON THE

PROPERTY IS MINIMAL WITH LITTLE SOD

NEEDED

SEAWALL COMPLETE READY FOR SOD

SEAWALL COMPLETE READY FOR SOD

THE NEW SEAWALL CAN BE INSTALLED ABOVE THE

EXISTING AND CAN BE RE LEVELED AND RE

ALIGNED

EVEN WHEN STRUCTURES APPEAR TO BE TO

CLOSE THE INSTALLATION CAN BE ACHIEVED WITH

SMALLER EQUIPMENT