samtec.com/BullsEye 40 GHz, Gen 2 Bulls Eye ® Assemblies Pogo-pin for signal and ground Compression interface design, small footprint and high-cycle count make Bulls Eye ® ideal for high-performance test applications. • High-density array test point – Double-row (BE40A) • Advanced Cable solutions – 23 AWG, solid dielectric – Low-loss microwave – Copper foil shield • Microstrip or Stripline PCB Transmission • Replacement components (cable and block) • 50 Ω impedance • Phase-matched pairs • End 2: 2.92 • Cable management available with protective sleeve • Test boards available for performance verification, contact [email protected]Backward compatible with BDRA Gen 1 Microstrip Stripline Pogo-pin design for both signal and ground BE40A Signal Ground BE40A Compression interface to the board
2
Embed
BullsEye - Samtec Microelectronicssuddendocs.samtec.com/ebrochures/bullseye_flyer_40_ghz.pdfBulls Eye ® Assemblies Pogo-pin for signal and ground Compression interface design, small
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
samtec.com/BullsEye
40 GHz, Gen 2 Bulls Eye® AssembliesPogo-pin for signal and ground
Compression interface design, small footprint and high-cycle count make Bulls Eye® ideal for high-performance test applications.
• High-density array test point– Double-row (BE40A)
20 GHz, Gen 1 40 GHz, Gen 2 Up to 65 GHzin Development
BQRA Series BDRA Series BE40A Series TBD
TBD
InstallationThere are a variety of series within the Bulls Eye® family, and while the attachment process is similar, each have unique specifications that need to be observed. For questions, please contact: [email protected]