Prime Archives in Material Science: 3 rd Edition 1 www.videleaf.com Book Chapter Buckling and Post-Buckling Behavior of Uniform and Variable Density Lattice Morphologies Aamer Nazir 1,2 and Jeng-Ywan Jeng 1,2,3 * 1 High Speed 3D Printing Research Center, National Taiwan University of Science and Technology, ROC 2 Department of Mechanical Engineering, National Taiwan University of Science and Technology, ROC 3 Consultant Professor, LungHwa University of Science and Technology, Taiwan, R.O.C *Corresponding Author: Jeng-Ywan Jeng, High Speed 3D Printing Research Center, National Taiwan University of Science and Technology, No. 43, Section 4, Keelung Road, Taipei 106, Taiwan, ROC Published June 07, 2021 This Book Chapter is a republication of an article published by Jeng-Ywan Jeng, et al. at Materials in October 2019. (Nazir, A.; Arshad, A.B.; Jeng, J.-Y. Buckling and Post-Buckling Behavior of Uniform and Variable-Density Lattice Columns Fabricated Using Additive Manufacturing. Materials 2019, 12, 3539. https://doi.org/10.3390/ma12213539) How to cite this book chapter: Aamer Nazir, Jeng-Ywan Jeng. Buckling and Post-Buckling Behavior of Uniform and Variable Density Lattice Morphologies. In: M Iqbal Khan, editor. Prime Archives in Material Science: 3 rd Edition. Hyderabad, India: Vide Leaf. 2021. © The Author(s) 2021. This article is distributed under the terms of the Creative Commons Attribution 4.0 International License(http://creativecommons.org/licenses/by/4.0/), which