N-1759 September 1986 NCEL By Robert N. Murtha Technical Note Sponsored By Department of Defense Explosives Safety Board BLAST DESIGN PROCEDURE FOR tFLAT SLAB STRUCTURES ABSTRACT 'A general step-by-step procedure was developed for designing flat slab structures to resist dynamic blast loads. The procedure is consistent with the Navy's current blast-resistant design manual NAVFAC P-397 and is based on an equivalent single-degree-of-freedom (SDOF) model of a flat slab. The distribution of reinforcement throughout the slab is based on the elastic distribution of design moments outlined by the American Concrete Institute (ACl). The step-by-step procedure is easily adapted to flat slabs of any configuration and considers both flexural and shear behavior. C)- NAVAL CIVIL ENGINEERING LABORATORY PORT HUENEME, CALIFORNIA 93043 Approved for public release; distributon is unlimited.
BLAST DESIGN PROCEDURE FOR tFLAT SLAB STRUCTURES
May 20, 2023
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Related Documents
