Before commencing assembly, please read these instructions thoroughly! PRINTED IN JAPAN 64271010-2 *SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. htpp://www.kyosho.com © 2010 KYOSHO / KFW006 for KF01 INSTRUCTION SHEET No.KFW006 Thank you for purchasing this product. Before installation, please carefully read and follow the instructions on this sheet in conjunction with the instruction manual of your kit. Firmly tighten the set screws onto the flat spot. Ball Diff. Set Symbols used throughout the instruction manual, comprise: Apply grease. Apply threadlocker (screw cement). Must be purchased separately! Assemble in the specified order. 1/8 8 Diff Ball 1/8 Diff Ball Note the direction Diff Washer 1 4.8x10mm 5mm Thrust Bearing 4.8x10mm Thrust Bearing 1 Taper Washer Taper Washer 2 6x10mm Bearing 6x10mm Bearing 6x10mm Bearing 1 5x10mm Bearing 5x10mm Bearing 1 4x 4mm 4x 4mm Set Screw Too loose Diff slips.(Power loss) Tighten Ideal Diff dosen't slip.(Smooth) Too tight Diff dosen't work. Loosen To find the appropriate ball diff setting, make small adjustments and check by running the car. Please also refer to the below chart. Ball diff can be adjusted by tightening or loosening the wheel nut. SPARE PARTS Set Screw(M4x4/10pcs) Shield Bearing(5x10x4)4Pcs Shield Bearing(6x10x3)2Pcs Ball Diff. Shaft Thrust Bearing(4.8x10x4)1Pcs Diff. Ball(1/8 Inch/10Pcs/SPADA09) Thrust Diff. Ring(2Pcs/TF-5)