This Auto Dialer is a single channel voice dialer that can be used with any device that can provide a normally open or normally closed contact. The Auto Dialer can be programmed to store up to four numbers to dial, including standard (voice) telephones, most cellular telephones, and pagers. The Auto Dialer will deliver a recorded message for up to 16 seconds. Auto Dialer Installation Instructions Note: These instructions are intended as a quick reference for the most common installation of the Auto Di- aler when used with a control panel. For complete instructions, see the included Installation and Instruction Manual for the Automatic Voice Dialer. Before beginning installation, read the entire instruction manual for the AVD-45c Automatic Voice Dialer. For specific questions or problems please call SJE-Rhombus Technical Support at 1-800-RHOMBUS, Monday – Friday 7:00 AM – 6:00 PM, CT. PROGRAMMING TIPS 1. When programming for pagers, call the desired pager from the telephone number and telephone line that the Auto Dialer will be attached to. Record the time required for the pager service to answer. Use that time for programming the required number of pauses needed. Each pause is two seconds in length. 2. If a cell phone does not ring before the Auto Dialer hangs up, program the cell phone number into the Auto Dialer with pauses after the number. Note: The number of pauses will depend on each cell phone and must be tested. 3. If a delay is desired before the Auto Dialer calls out to help prevent nuisance calls, set the entry delay to "on" and the channel to "continuous" mode. This will require that channel activation to be tripped for 20 seconds before dialing out and remain activated throughout the dialing process. TESTING THE AUTO DIALER 1. All people or organizations should be notified that the auto dialer will be calling and the action you would like them to take. 2. Apply power to the unit. 3. Be sure an active telephone line and all wiring is connected to the auto dialer. 4. Press the "M" key until "Operate" appears in the LCD. 5. Trigger the signaling device to cause the auto dialer to call out. 6. The auto dialer will dial the numbers stored in locations 1-4. The out going message will be delivered when the auto dialer receives an answer. For pager numbers, the pager code will be transmitted instead of the outgoing message. 7. The auto dialer is now ready for operation. 8. Test the Auto Dialer system once a month to insure the outgoing message is being sent and received. 22650 County Highway 6 n P.O. Box 1708 n Detroit Lakes, Minnesota 56502 USA 1-888-DIAL-SJE (1-888-342-5753) n Phone: 218-847-1317 n Fax: 218-847-4617 n E-mail: [email protected] 3. Connect the power cord, tele- phone line and alarm cable. It is ok to use your own telephone cable. 6. For programming refer to manual. 2. Determine indoor mounting location. If installing on wall, use the two screws and place parallel 5 3 / 16" apart. 5. If desired, install a 9V battery for battery backup, and plug in unit. 1. Verify all components are supplied; AVD-45c, power supply, screws, alarm cable, phone cable and manual. 4. Connect yellow and white wires from the alarm cable to the control panel N.O. or N.C. alarm contact.