It is always recommended to anchor the unit in to the ground. Drill through the four holes in the base of the unit using 6mm dia masonry drill to a depth of 70mm. Screw in the anchor fixings. (These have a self cutting thread). If not anchoring the unit, fit the self seal plugs BEFORE BUILDING to block the fixing holes from underneath. TOOLS REQUIRED Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill and a 13mm socket or spanner. GLADIATOR ZSCREW32 x8 ZSILCOL1 x1 ZSCREW04 x4 ZSCREW100 x320 ZSCREW340 x24 32670 x18 6mm Dia. 13mm Spanner 18V ZCOMPPLZS02 x8 ZCOMPPLAS22-23-24 x12 4x 2mm, 4x 3mm, 4x 5mm BASE INSTRUCTIONS Flat and firm base. Recommended: concrete, tarmac or paving flags. Min. distance from walls/ shrubbery: 1000mm. Min. base size (WxDxH) 2410mm x 2640mm x 50mm. LEVELING THE UNIT Correctly level the constructed unit using the shims (ZCOMPPLAS) provided prior to fixing the unit to the ground. Slide the packing pieces under the corners of the unit base as required until an equal gap has been achieved around the door allowing for its smooth operation and alignment. RH FRT TOP PANEL 39873 x1 RH REAR TOP PANEL 39869 x1 LH REAR TOP PNL 39867 x1 SHORT TOP CAP 39892 x1 ROOF JOINT STRIP 40881 x2 LH BACK PANEL 39832 x1 LH REAR SIDE PANEL 32874 x1 RH REAR SIDE PANEL 32875 x1 REAR BASE PNL 39831 x1 FRONT BASE PNL 39841 x1 TOP COVER CHANNEL 40063 X2 FLOOR COVER CHANNEL 40062 x2 FASCIA 39848 x1 ROOF BRACE 39897 x1 RH DOOR 32944 x1 RH FRONT PANEL 39861 x1 LH FRONT PANEL 39860 x1 LH DOOR 32943 x1 RH FRT SIDE PANEL 39815 x1 SIDE COVER CHANNEL 32916 x2 LH FRT SIDE PANEL 39814 x1 RH BACK PANEL 39833 x1 LONG TOP CAP 39893 x1 LH FRT TOP PNL 39871 x1 For maintenance instructions of this product visit www.asgardsss.co.uk Warning: some panels may weigh over 20Kg. Beware of manual handling Warning: Please keep this key card safe! Refer to if replacement key is required. x2 TOP FRONT BACK CHANNEL 40094 x2 SEALANT 00001 YOUR UNIQUE KEY CODE Posi-Driv Screwdriver