ARDYNE TECHNICAL BULLETIN NEW SYSTEM AVOIDS MILLING 158M CEMENTED CASING OneTrip DHPT System First Run Casing Recovery Success Ardyne’s new OneTrip DHPT System has had its first successful field run in the Norwegian North Sea. The system takes the POWER of the Downhole Power Tool (DHPT), and combines it with the FLEXIBILITY of an individually controlled cutter and spear, to allow MULTIPLE ATTEMPTS to recover casing in a single trip. The DHPT was anchored in the rotary table, with Ardyne’s axial load operated (ALO) valve, flow release mechanism (FRM) Spear, and casing cutter and taper mill below. The System successfully recovered 158m of partially cemented 13-3/8” casing by cutting, jacking and pulling in 12 segments, without wear to the rig. Partial cement prevented conventional recovery of 13-3/8” casing. The DHPT was anchored in the rotary table, providing pulling force in excess of the rig capacity. This method could be used in RIGLESS CASING RECOVERY On several runs the casing could not be pulled free, the casing was recut and a smaller section was pulled, all in the same trip. NO MILLING + NO WASTED TRIPS. © Ardyne, 2017 www.ardyne.co DHPT ALO VALVE FRM SPEAR TAPER MILL CASING CUTTER
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
ARDYNE TECHNICAL BULLETIN
NEW SYSTEM AVOIDS MILLING 158M CEMENTED CASINGOneTrip DHPT System First Run Casing Recovery Success
Ardyne’s new OneTrip DHPT System has had its first successful field run in the Norwegian North Sea. The system takes the POWER of the Downhole Power Tool (DHPT), and combines it with the FLEXIBILITY of an individually controlled cutter and spear, to allow MULTIPLE ATTEMPTS to recover casing in a single trip.
The DHPT was anchored in the rotary table, with Ardyne’s axial load operated (ALO) valve, flow release mechanism (FRM) Spear, and casing cutter and taper mill below. The System successfully recovered 158m of partially cemented 13-3/8” casing by cutting, jacking and pulling in 12 segments, without wear to the rig.
Partial cement prevented conventional recovery of 13-3/8” casing. The DHPT was anchored in the rotary table, providing pulling force in excess of the rig capacity. This method could be used in RIGLESS CASING RECOVERY
On several runs the casing could not be pulled free, the casing was recut and a smaller section was pulled, all in the same trip. NO MILLING + NO WASTED TRIPS.
© Ardyne, 2017www.ardyne.co
DHPTALO VALVE
FRM SPEAR
TAPER MILLCASING CUTTER
Related Documents
