Antenna Antenna Radome Radome Effects on Effects on High Performance SATCOM High Performance SATCOM Antenna Systems Antenna Systems Dr. D. J. Kozakoff Consultant and Chief Scientist USDigiComm Corp. ‐ Marietta, GA R. Ciano Senior Antenna Systems Engineer General Atomics Corp. ‐ San Diego, CA
25
Embed
Antenna Radome Effects on High Performance SATCOM · PDF fileAntenna Radome Effects on High Performance SATCOM Antenna Systems ... Multilayer Wall Concepts Since ... Sky Noise Temperature
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Antenna Antenna RadomeRadome
Effects onEffects on High Performance SATCOMHigh Performance SATCOM Antenna SystemsAntenna Systems
Dr. D. J. KozakoffConsultant and Chief ScientistUSDigiComm
Corp. ‐
Marietta, GA
R. CianoSenior Antenna Systems EngineerGeneral Atomics Corp. ‐
San Diego, CA
Presentation GoalsPresentation Goals
� Discuss Special Problems Encountered When Enclosing a SATCOM, and in Particular a Satellite on the Move (SOTM) Antenna within a Radome
� Investigate Considerations of Utilizing a SOTM Phased Array Antenna as Opposed to a Mechanically Gimbaled Antenna with the Dome
Uplink/Downlink Frequency Bands Uplink/Downlink Frequency Bands Commonly Used for SATCOMCommonly Used for SATCOM
RadomeRadome
Bandwidth Needs to Extend Bandwidth Needs to Extend from Downlink to Uplink Frequenciesfrom Downlink to Uplink Frequencies
Problem Worsens as Uplink Frequency Increases
� Dual Frequency (Uplink & Downlink) Requirements Pushes Design Towards Multilayer Wall Concepts Since Monolithic Typically Cannot Provide Suitable Bandwidths
� The Most Common Types Use 3-Layers (A-Sandwich) or 5-Layers (C-Sandwich) Consisting of Higher Dielectric “Skin”
Materials and Alternating Layers of Very Low Dielectric Core Materials
Example of Optimized CExample of Optimized C--SandwichSandwich (for 20GHz to 30GHz Bandpass)(for 20GHz to 30GHz Bandpass)
� Antenna Noise Temperature
� Radome Effect on Decreasing Antenna Gain
� Radome Effect on Decreasing Antenna G/T Ratio
� Increase in Link Bit Error Rate (BER) Due to Effect
Other Considerations inOther Considerations in Specifying Radome PerformanceSpecifying Radome Performance
Sky Temperature vs FrequencySky Temperature vs Frequency (Antenna EL Angle is a Parameter)(Antenna EL Angle is a Parameter)
Ref: www.antetec.com
Sky Temperature vs FrequencySky Temperature vs Frequency (Plot Assumptions)(Plot Assumptions)
� Plot Assumes a Lossless Antenna
� Plot Doesn’t Include Hot Earth Contribution through Antenna Sidelobes
� At Near Zenith Antenna Pointing the Sky Noise Temperature is Less Than 10°K
Effect of Radome Loss onEffect of Radome Loss on Ku Band Antenna Noise TemperatureKu Band Antenna Noise Temperature
Effect of Radome Loss onEffect of Radome Loss on Ku Band Antenna Noise TemperatureKu Band Antenna Noise Temperature
Eb
/ NO
= Pt + Gt
- Lsp
- La
- k – fb + (Gr
/ T)
Where:
Eb
/ NO
= Energy per bit to noise density at receive antenna (dB)
Pt
= Transmit power (dBW) at satelliteGt
= Transmit antenna gain (dB) on satelliteLsp
= Free space loss (dB)k
= Boltzman’s constant (dB/K)
fb = Bit rate (dBHz)Gr
/ T
= Receive antenna gain to antenna/receiver noise temperature ratio (dB/K)
SATCOM Receive Link BudgetSATCOM Receive Link Budget
Ku Band Change in G/T Due to Ku Band Change in G/T Due to Radome LossRadome Loss
G/T Decreases
Faster Than the
Radome Loss
Increases
G/T Decreases
Faster Than the
Radome Loss
Increases
Ka Band Change in G/T Due to Ka Band Change in G/T Due to Radome LossRadome Loss
QPSK BER Related to EQPSK BER Related to Eb b / N/ Noo
� The Antenna Beam can Track a Satellite and Compensate for the Motion its Platform. On Ships for Example, a Specialized Pitch and Roll Stabilized Antenna Pointing Gimbal is Used to Eliminate the Effect of a Ship’s Motion.
� The Beam can be Configured to Operate in a Monopulse Mode for Autotrack
� Multiple Simultaneous Beams can be Used toTrack Multiple Satellites
� Aperture Weightings for Very Low Sidelobes can be Employed (i.e. –
Taylor or Chebychev Distributions
Benefits for SOTM PhasedBenefits for SOTM PhasedArray AntennasArray Antennas
� Must Populate a Single Aperture with Both Uplink Band and Downlink Band Antenna Elements
� Must Increase Aperture Size for Needed Effective Area so That Antenna Gain is Achieved Over the Entire Scan FOV
� Radome Design is More Complicated Because the Ray AOI’s are Different Than a Mechanically Steered Antenna
� Prove That Regulatory Requirements Such as Antenna Sidelobes are Satisfied for All Possible Pointing Angles
� Transmit and Receive Beams Must Point in Same Direction (Called “Registration Error”, the Difference Between the Uplink & Downlink Band BSE’s
Problems for SOTM PhasedProblems for SOTM PhasedArray AntennasArray Antennas
Thank You for ViewingThank You for Viewing Our PresentationOur Presentation