Announcements, Week 6 • Happy Darwin Day! (b. Feb. 12, 1809) • BPAE cell reports due today. • Paper discussion (Becky): Garcia-Pichel et al. 2001 • TBA this week: Drosophila embryos, mouse intestine cryostat sections – Reports due Feb. 19. – TBA for Group 4 following lecture. • Week 7, Feb. 19: Fluorescent probes, live cell labeling – TBA: onion epithelium, report due Feb. 26 – Paper discussion next week (Rachel): Tan et al. 2005. • Week 8, Feb. 26: Midterm exam on lecture, lab material; microscope checkout (change from end of semester) during TBA time – allow 30 minutes each – Project descriptions also due.
Announcements, Week 6. Happy Darwin Day! (b. Feb. 12, 1809) BPAE cell reports due today. Paper discussion (Becky): Garcia-Pichel et al. 2001 TBA this week: Drosophila embryos, mouse intestine cryostat sections Reports due Feb. 19. TBA for Group 4 following lecture. - PowerPoint PPT Presentation
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Announcements, Week 6• Happy Darwin Day! (b. Feb. 12, 1809)• BPAE cell reports due today.• Paper discussion (Becky): Garcia-Pichel et al. 2001• TBA this week: Drosophila embryos, mouse intestine cryostat
sections– Reports due Feb. 19.– TBA for Group 4 following lecture.
• Week 7, Feb. 19: Fluorescent probes, live cell labeling– TBA: onion epithelium, report due Feb. 26– Paper discussion next week (Rachel): Tan et al. 2005.
• Week 8, Feb. 26: Midterm exam on lecture, lab material; microscope checkout (change from end of semester) during TBA time – allow 30 minutes each– Project descriptions also due.
Lecture Outline
A. Immunolabeling (cont’d)1. General considerations2. Autofluorescence and background3. Controls
B. Fluorescence1. Defined2. Absorption and emission spectra3. Filters4. Cross-over (bleed-through) compensation
C. TBA: Drosophila and mouse intestine samples
Detection Methods
Method Advantages Disadvantages Recommended for
Fluorescence High resolution
Doubling labeling possible
Staining live cells possible
Requires special microscope
High resolution studies
Double labeling
Enzyme High sensitivity
Only need bright field light microscopy
Permanent
Low resolution
Endogenous enzyme activities
Double staining difficult
Substrate toxicity
Low resolution studies
Rapid antigen screens
From: Harlow and Lane, 1999
Antibody Choice
Polyclonal antibodies
Monoclonal antibodies
Pooled monoclonal antibodies
Signal strength Excellent Fair Excellent
Specificity Good, but some background
Excellent, but some cross-reactions
Excellent, by avoiding any antibodies with cross reactions
Good features Signal strength Specificity Signal strength and specificity
Bad features Background
Often need to titre
Lower signal strength
Availability
From: Harlow and Lane, 1999
Immunolabeling of live cells
• Commonly used for surface antigens.
• Cellular endocytosis can be used to take up antibody.
• Streptolysin-O (SLO) can be used to permeabilize cells and retain viability.
Troubleshooting
• Problem 1: No specific staining with single labeling
• Possible causes:– Antigen not cross reactive, destroyed or inaccessible
• Perform positive control, obtain fresh material, permeabilize– Primary antibody dead or not concentrated enough
• Obtain fresh or increase concentration– Secondary antibody dead or not concentrated enough
• Obtain fresh or increase concentration– Protocol errors
• Review protocol, modify
• Problem 2: Artifactual staining: do neg. controls.
Autofluorescence
• Autofluorescence is caused by the intrinsic properties of some structures, independent of antibody labeling.– Aromatic amino acids and other molecules containing ring
structures– Chitin, chlorophyll, collagen, elastin– Often worse with shorter wavelength excitation that with longer.– Aldehyde cross-linking (especially gluteraldehyde), methanol
fixation
• Low level of autofluorescence may be helpful to see limit of cells or tissues.
• Negative control with no fluorescent probe determines location and limits of autofluorescence.
Background staining
• Caused by binding of antibody.• Nonspecific background: Binding of antibodies by parts
other than antigen-binding site– Spin down prior to use to remove large particles– Titrate concentrations to minimum– Use blocking reagents, e.g. BSA, nonfat dry milk, normal serum
from same species as labeled antibody– Use detergent in all solutions– Reduce incubation times, increase wash times and numbers
• Specific background: Caused by antigen binding in side reactions– Dilute primary antibody in 1% normal serum from same species
as labeled antibody
Controls for immunofluorescence labeling
• Spectral properties of the available dyes limit the experimental freedom.Spectral properties of the available dyes limit the experimental freedom.• Often it is even difficult to clearly separate two fluorescence markers.Often it is even difficult to clearly separate two fluorescence markers.• With more markers, the problem grows increasingly complex.With more markers, the problem grows increasingly complex.
Crossover
Controls for Double Labeling (Indirect Immunofluorescence)
– Pre-immune Serum or non-immune serum from rabbit + Anti-rabbit IgG secondary antibody-fluorescein.
Controls for Double Labeling, Indirect Immunofluorescence (cont’d)
• Negative Controls for Secondary Specificity:– Primary 1 + Secondary 2, Primary 2 + Secondary 1– Look for secondaries that say “no cross-reactivity”
• Staining with one antibody and another non-antibody probe (e.g. rhodamine-phalloidin or Sytox Green) is a simpler matter.
• If you want to use two monoclonal antibodies, one solution is to conjugate fluorochromes to them directly, e.g.– mouse anti-tubulin-rhodamine– mouse anti-actin-fluorescein
• Sequential staining is also possible, fixing between steps.• Or another way is:
Fab Fragments for Blocking and Double Labeling of Primary Antibodies from the Same Host Species(Jackson ImmunoResearch Laboratories, Inc.)
Key:
Rabbit anti-Antigen X
Rabbit anti-Antigen Y Fluorescein (FITC)
Fab fragment Goat anti-Rabbit IgG (H+L) Rhodamine Red-X (RRX)
Goat anti-Rabbit IgG (H+L)
See alternative methods at www.jacksonimmuno.com
Imaging Double-Labeled Samples
• Select dyes that that are well-separated in their absorption and emission spectra.– E.g. use Texas Red (596-620) instead of
rhodamine (550-580) with fluorescein (490-520).
• Be careful about turning up the gain: you can make almost anything “fluorescent.”
• Compensate for fluorescence cross-over (discussed below).
What is fluorescence?Single-photon excitation
• Where a molecule emits light at a specific wavelength when irradiated by light of a shorter wavelength.
• Jablonski diagram depicts molecular events of single-photon fluorescence:
• Choose fluorochromes with as widely separated spectra as possible.
• Adjust concentrations of fluorescent stains so that intensities are close to equal
• When selecting fluorescent probes for multiply-labeled specimens, the brightest and most photostable fluorophores should be reserved for the least abundant cellular targets.
• Absorption spectra are generally skewed towards shorter wavelengths whereas emission spectra are skewed towards longer wavelengths.
• For this reason, multicolor fluorescence imaging should be conducted with the reddest (longest wavelength peak emission) dye imaged first, using excitation wavelengths that are only minimally absorbed by the skewed spectral tails of the bluer dyes.
Balancing emission intensities reduces much crossover
Em
issi
on
on
ly
Controls for Double Labeling
• Background control: specimen without secondary antibody or fluorochrome– Controls for autofluorescence
• Bleed-through controls: specimens labeled with each fluorochrome separately. To determine maximum gain before bleed-through:1. Image green-labeled sample w/488 in Ch. 1, look for
cross-over in Ch. 2.2. Image red-labeled sample w/543 in Ch. 2, look for
crossover in Ch. 1.3. Using these settings, image double-labeled sample
(same stain concentrations as above) using sequential scan.
Quantum Dots
• Quantum dots are semi-conductor nanocrystals coated with inert polymer to which biomolecules can be attached, e.g. antibody.
• Advantages:– Less photobleaching– High quantum yield– Narrow, symmetrical emission spectra means less spectral overlap.– Various colors can be excited by same laser line
TBA this week
1. Use your stained fly slides to collect Z-series of (a) lower mag overview (lastname 4A), and (b) high mag detail (lastname 4B), (c) negative control (low mag, lastname 4C).
• Use references on reserve in library to identify stages and structures stained.
• Save images in Week 6 folder and turn in a report next Monday (see new format).