Analog output module MOUT-4s General features The MOUT-4s module is a component of the Ampio Smart Home system and has been designed for integration with devices with control voltage input, compatible with one of the following standards: 0-10V, 1-10V, 0-5V. There is a variety of devices, available in the market, which may have their parameters adjusted by applying suitable voltage to the control input. It can be for examplelighting fixtures, recuperators and much more. The module has four voltage outputs. The output voltage can be controlled within range of 0-10V. Module is controlled via CAN-Bus. Required voltage to power the module is 11-16V DC. The device is equipped with two connectors: CAN bus and output with ground. There are five LED indicators: four red and one green. The green LED indicates the status of CAN communication one regular flash every 1 sec. - CAN-Bus communication in order two regular flashes every 1 sec. - module is not receiving information from other SmartHome modules three regular flashes every 1 sec. - module cannot send information to CAN-Bus The red LEDs indicate control states of individual outputs. Programming The module may be programmed with a special programmer, available for authorised technicians, and the Ampio SmartHome CAN configurator software. This program provides for setting up the module’s response to input signals and other information from the CAN bus. MODULE DESCRIPTION ver 1.6, 02.09.2020 Copyright © 2020 Ampio Sp. z o.o. All rights reserved. This document is not intended for reproduction or distribution. www.ampio.pl Technical data Power supply voltage 11-16V DC Current consumption 30 mA Dimensions width 35 mm heigth 120 mm depth 65 mm maximal 455 mA quiescent Single output load capacity 100 mA Number of analog outputs 4