http://www.iaeme.com/IJCIET/index.asp 746 [email protected] International Journal of Civil Engineering and Technology (IJCIET) Volume 8, Issue 11, November 2017, pp. 746–752, Article ID: IJCIET_08_11_076 Available online at http://http://www.iaeme.com/ijciet/issues.asp?JType=IJCIET&VType=8&IType=11 ISSN Print: 0976-6308 and ISSN Online: 0976-6316 © IAEME Publication Scopus Indexed ALUMINUM ALLOYS AND BEHAVIOR UNDER CYCLIC LOADING IN JOINTS OF TRUSS STRUCTURES Ragip Hadri Department of Civil Engineering, University of Prishtina, Bregu I Diellit P.N,Prishtine Ali Muriqi* Department of Civil Engineering, University of Prishtina, Bregu I Diellit P.N,Prishtine *Corresponding author ABSTRACT Aluminum is the second most widely specified metal in building after steel, and is used in all sectors from commercial building to domestic dwelling. This paper contains overview of use of aluminum in building construction, specifically in connections of trust elements. This paper also contains the properties of aluminum alloys, setup of testing, advantages and no advantages under the cyclic loads. The used properties parameters during the testing are compared with the parameters given by the manufacturer, the standards of the European Aluminum Association and Eurocode 9. Testing of the models was performed on a hydraulic press (pulsator), Amsler''.The behaviour of join was focused in long period during the testing to analyze the failure mode and to compare with dynamic factor using in analytical method using during the experiment. This concept was reasonly accepted such dynamic coefficient in the diagonal D1, such trust element in value γD = 1,6. European Aluminium Association still doing research on getting the dynamic coefficients of fatigue for aluminum alloys and this research will present the contribution in this regard. Keywords: Aluminum Alloys, Connections, Testing, Cyclic loads, Failure Cite this Article: Ragip Hadri and Ali Muriqi, Aluminum Alloys and Behavior under Cyclic Loading in Joints of Truss Structures, International Journal of Civil Engineering and Technology, 8(11), 2017, pp. 746–752 http://www.iaeme.com/IJCIET/issues.asp?JType=IJCIET&VType=8&IType=11 1. INTRODUCTION The increasing use of engineering materials in different types of loading requires that the materials have good mechanical properties in these conditions. Fatigue is one of the principle damage mechanisms or materials operating under loading conditions. During the cyclic
ALUMINUM ALLOYS AND BEHAVIOR UNDER CYCLIC LOADING IN JOINTS OF TRUSS STRUCTURES
Jun 20, 2023
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Related Documents
