Delft University of Technology Additive manufacturing of functionally graded inconel 718 Effect of heat treatment and building orientation on microstructure and fatigue behaviour Ghorbanpour, Saeede; Deshmukh, Kaustubh; Sahu, Saswat; Riemslag, Ton; Reinton, Elise; Borisov, Evgenii; Jiang, Quanxin; Sanchez, María Terol; Knezevic, Marko; Popovich, Vera DOI 10.1016/j.jmatprotec.2022.117573 Publication date 2022 Document Version Final published version Published in Journal of Materials Processing Technology Citation (APA) Ghorbanpour, S., Deshmukh, K., Sahu, S., Riemslag, T., Reinton, E., Borisov, E., Jiang, Q., Sanchez, M. T., Knezevic, M., Popovich, V., & More Authors (2022). Additive manufacturing of functionally graded inconel 718: Effect of heat treatment and building orientation on microstructure and fatigue behaviour. Journal of Materials Processing Technology, 306, [117573]. https://doi.org/10.1016/j.jmatprotec.2022.117573 Important note To cite this publication, please use the final published version (if applicable). Please check the document version above. Copyright Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons. Takedown policy Please contact us and provide details if you believe this document breaches copyrights. We will remove access to the work immediately and investigate your claim. This work is downloaded from Delft University of Technology. For technical reasons the number of authors shown on this cover page is limited to a maximum of 10.