ADDING BAR TACK AT SIDE VENT NOVEMBER 21ST 2011
Mar 26, 2015
ADDING BAR TACK AT SIDE VENT
NOVEMBER 21ST 2011
Style:men’s SS Rayon Shirt: Bar tack at Side vent.
Requirement: Bar tack at side vents are required for Durability.
Issue: Yarn is Pulling while adding bar tack at Side vent. In darker colors it is more visible as white yarns are showing.
Solution: Bar tack can be used at side vent without yarn pulling issue with below m/c set up.
M/c name- Juki Pattern # 1 X # 90 Y # 75 M/C Speed- 2000 Tension – 35 Needle size – 9 (Ball Point) DP # 5 Bar tack width at End product - ½”
Style:men’s SS Rayon Shirt: Bar tack at Side vent.
M/c set up:
>Pattern # 1>X # 90>Y # 75>M/C Speed- 2000>Tension – 35>Needle size – 9 (Ball Point)>DP # 5>Bar tack width at End product - ½”
Style:men’s SS Rayon Shirt: Bar tack at Side vent.
Check the needle point regularly.Must not use Blunt needle.
Style:men’s SS Rayon Shirt: Bar tack at Side vent.
Ensure proper lighting at M/c
Existing bar tack M/C do not have adequate lighting.pls add More light if required
Style:men’s SS Rayon Shirt: Bar tack at Side vent.
>Use Guideline if needed to ensure correct angle & placement.>Over tacking is not Acceptable.>Try to avoid placing bar tack at single layer
Style: men’s SS Rayon Shirt: Bar tack at Side vent.
Ensure thread tension,& maintain m/c regularly
Style:: men’s SS Rayon Shirt: Bar tack at Side vent.Bar tack on mock ups with specific M/C Set up. Done by operator at Sewing Floor In 10 Pcs.
Thank You