www.canbusemulator.com/en USER MANUAL +90 530 937 46 36 erenakarsubasi ADBLUE EMULATOR DAF
www.canbusemulator.com/en
USER MANUAL
+90 530 937 46 36erenakarsubasi
ADBLUE EMULATOR DAF
www.canbusemulator.com/en
Installation
Emulator
For
DAF
Euro
6
DAF EURO 6 ADBLUE CANCEL EMULATOR INSTALLATIONYou must attach the emulator to the rear of the silencer under the EAS ECU.You must first disconnect the NOx sensor cables and connect the emulator cables to the NOx cables.You must obtain fuse F22 (e497, 15A)
CAN cables
are
located
at
the
top
of
the
NOx
socket.
Car
side
Emulator
sideCAN
H
-------------------->
YELLOW
cableCAN
L
-------------------->
GREEN
cablePOWER
(+)
-------------->
RED
cableGND
(-)
------------------->
BLACK
cable
IMPORTANT
NOTE:
Only
the
CAN
cables
are
to
be
connected
from
the
NOx
socket
as
the
truck's
fuse
has
been
taken.
For
power
connections
you
need
to
use
ground
(GND)
and
contact
(+).
You
must
clear
the
error
codes
from
the
engine
ECU.
If
you
do
not
have
DAVIE
software,
you
can
use
DAF
Euro
6
DTC
Eraser.
The
connection
type
DAF460
/
480
is
the
same
but
the
NOx
socket
locations
are
different.
The
following
are
shown.
DAF460
1. Tray type: you must get fuse F22 (e497, 15A)2. Tray type: You should take fuses D25 and D26 (10A and 15A).
Daf vehicles have two types of fuse plates, which are illustrated below. Which type of vehicle If there is a fuse tray, follow the instructions.
muratRectangle
www.canbusemulator.com/en
Installation
Emulator
For
DAF
Euro
6
DAF480
1.Tab type fuse
www.canbusemulator.com/en
Installation
Emulator
For
DAF
Euro
6
1. Tray type fuse
If this fuse plate is installed in your vehicle, remove fuse D25 and D26.Connect the positive (+) line of the emulator to the contact line.