3 1 2 Secure the Retractor bracket on the bottom of the enclosure using the provided bracket screws. Insert the pin through the Retractor mounting hole on the side of the bracket, and use the clip to secure the pin at the other end. 3 1 h ng Insert Retractor modules into the Retractor bracket. Accessories for Cable Cubby 202 • Setup Guide This guide provides instructions for assembling and installing two accessories for the Cable Cubby 202: the double-space AAP bracket and the Retractor bracket. AAP Bracket The AAP bracket accomodates two single-space AAPs in the Cable Cubby enclosure. Follow these steps to install your choice of AAPs and the AAP bracket. Retractor Bracket The Retractor bracket accommodates up to three Retractor modules in the Cable Cubby enclosure. Follow the steps below to install the bracket and Retractor modules. NOTE: See the next page for Retractor dimensions. Secure two single-space AAPs in the AAP bracket. 1 3 Secure the AAP bracket in the enclosure using the provided plate screws. Insert the cables through the bottom of the Cable Cubby and connect cables to the AAPs. 2 #4-40 Nut with Captive Washer 3 S t p
2
Embed
Accessories for Cable Cubby 202 Setup Guide · 68-2487-01 Rev. B 06 16 Retractor Dimensions When installing Retractor modules in the Cable Cubby, ensure that there is enough space
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
3
1
2
Secure the Retractor bracket on the bottom of the enclosure using the provided bracket screws.
Insert the pin through the Retractor mountinghole on the side of the bracket, and use the clip to secure the pin at the other end.
3
1
Secure two single-space AAPs in the AAP bracket.
1
3 Secure the AAP bracket in the enclosure using the provided plate screws.
Insert cables through the bottom of the Cable Cubby and connect cables to the AAPs.
2
#4-40 Nut with Captive Washer
3 Stp
hng
Insert Retractor modules into the Retractor bracket.
Accessories for Cable Cubby 202 • Setup Guide
This guide provides instructions for assembling and installing two accessories for the Cable Cubby 202: the double-space AAP bracket and the Retractor bracket.
AAP BracketThe AAP bracket accomodates two single-space AAPs in the Cable Cubby enclosure. Follow these steps to install your choice of AAPs and the AAP bracket.
Retractor BracketThe Retractor bracket accommodates up to three Retractor modules in the Cable Cubby enclosure. Follow the steps below to install the bracket and Retractor modules.
NOTE: See the next page for Retractor dimensions.
3
1
2
Secure the Retractor bracket on the bottom of the enclosure using the provided bracket screws.
Insert the pin through the Retractor mountinghole on the side of the bracket, and use the clip to secure the pin at the other end.
3
1
Secure two single-space AAPs in the AAP bracket.
1
3 Secure the AAP bracket in the enclosure using the provided plate screws.
Insert the cables through the bottom of the Cable Cubby and connect cables to the AAPs.
2
#4-40 Nut with Captive Washer
3 Stp
hng
Insert Retractors intothe Retractor bracket.
Accessories for Cable Cubby 202 • Setup Guide (Continued)
68-2487-01Rev. B06 16
Retractor DimensionsWhen installing Retractor modules in the Cable Cubby, ensure that there is enough space for the Retractor assembly under the table (see the Retractor dimensions below).