SPECIFICATION INSTALLATION INSTRUCTIONS Note Note PROD. CODE SIZE AGE RANGE F/ FALL HEIGHT HEAVIEST PART TOTAL WEIGHT Matrix K2 6030-053 8.02 x 9.49 x 6.65 10 years to adult 1.975m Approx 47 kg Approx 1477 kg 6030-053 Page 1 of 20 Solid steel components to BS 970 Pt 1 Steel Nominal Bore Tube (medium) to BS 1387 Aluminium casting made from LM6M Aluminium extrusion made from 6063A T6 Stainless steel to BS 1449 Pt 2 19mm thick HD polyethylene 100% recyclable non-toxic and complies with EN 71 19mm thick HD polyethylene 100% recyclable non-toxic with a textured non-slip surface one side and complies with EN 71 Standard fixings are plated and made to either BS 3692 or BS 4190 Non-standard fixings are anti-vandal and corrosion resistant Welds are from copper-free wire to BS EN 440 Low lead polyester powder paint to BS 71 Pt 3 Anodising to BS 3987 1 Read instructions thoroughly before commencing installation of unit 2 Excavate foundations as shown in the foundation plan 3 WHEN ASSEMBLING UNIT ENSURE CLAMPS ARE FITTED ON THE CORRECT STRUT IN THE CORRECT ORIENTATION 4 Assemble leg sections and fit below ground fixings. 5 Position in holes on bricks and support 6 Build "floor" between leg sections 7 Build remainder of unit. It is suggested that this is done in sections on the ground, which are then lifted onto unit already assembled. 8 Fit panels and nets as shown 9 Position slides on bricks in holes and attach to panels 10 Backfill all holes with a total 2.04 cubic m concrete (4 parts gravel/2 parts sand/1 part cement) 11 Allow concrete to set for 48 hours ENSURE ALL INSTALLATION AIDS ARE REMOVED BEFORE FIRST USE In accordance with 6.1.3 EN1176-1:2008 we recommend that slides do not face south or near due south due to heat build up.