Select and label the “scales” for the handle 1. The pieces for the handle are called “scales” and can be cut from domestic or exotic hardwoods, acrylic, bone, antler or other suitable material. (They are not included with the kit.) For this kit, start with scales that are at least 3" long by 1 1 ⁄2" wide and 1/4" to 3/8" thick. 2. Identify the Left and Right Scales and determine the inside and outside faces. Label accordingly. (As used here, “right” and “left” refer to the sides of the handle as oriented when the tool is held in the hand with the blade extended, edge down.) Cut the scales 1. Measure the distance between the shoulders of the metal Front and Rear Bolsters on the Knife Body (1). (It should be around 2 3 ⁄8".) Cut the scales slightly long and then test fit and trim to achieve a snug fit. 2. Fit each of the scales onto the knife and use the body to trace the final outline on the scales. 3. Using a coping saw, scroll saw or band saw, cut the scales slightly oversized, at least 1/16" outside the trace line. 1 Folding Pocket Knife Hardware Kit Instructions 57735 Danger indicates a hazardous situation that, if not avoided, will result in death or serious injury. Warning indicates a hazardous situation that, if not avoided, could result in death or serious injury. Caution indicates a hazardous situation that, if not avoided, may result in minor or moderate injury or property damage. Notice indicates important or helpful information and/or user tips. > Please read these instructions completely before beginning. > Be aware that the blade comes sharpened. For your safety, cover the edge with several layers of painter’s tape before you begin working on your custom knife kit. Remove the tape after assembly is complete; if necessary, remove any adhesive residue with hot, soapy water or acetone. Scales for handle sold separately