Easter
SIDE VIEW PAPER
FOAMCOR
Foamcor between layer
A good site to look at:http://www.helenmusselwhite.com/index.htm
© Helen Musselwhite : Art and Illustration
Art and design by Didier [email protected]
[] Cut out each piece, then glue the pieces in layers to form a 3D picture. Refer to the cover illustration for the order.
[] Between the layers, glue small squares cut from foamcor, balsa wood, or other lightweight material. These will act as support to raise each level slightly higher than the previous layer.
[] You may build a frame or box to place your picture in. Attach a string to the back to hang your picture on the wall.