8/2/2019 27AF61_SCM
1/28
SCHEMATIC DIAGRAM
WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETYPRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL.
CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate componentswhich have special characteristics important for safety and should be replaced only with types identical to those in theoriginal circuit or specified in the parts list. The mounting position of replacements is to be identical with originals.Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for thismodel. Do not degrade the safety of the receiver through improper servicing.
NOTE:
1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5%
tolerance carbon resistor, unless otherwise noted as the following marks.
1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt
1RF = Fuse resistor of 1 watt 10W = Cement of 10 watt
K = 10% G = 2% F = 1%
2. CAPACITOR Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in
?F, and the values more than 1 in pF.
All capacitors are ceramic 50V, unless otherwise noted as the following marks.
Electolytic capacitor Mylar capacitor
3. The parts indicated with " * " have special characteristics, and should be replaced with identical parts only.
4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with all
controls at normal, line voltage 120 volts.
5. Waveforms are taken receiving color bar signal with enough sensitivity.
6. Voltage reading shown are nominal values and may vary 20% except H.V.
MODEL : 27AF61 Chassis No. TAC0115
27AF41 Chassis No. TAC0116
8/2/2019 27AF61_SCM
2/28
SCHEMATIC DIAGRAM MODEL : 27AF61 Chassis No. TAC0115
27AF41 Chassis No. TAC0116
WARNING:BEFORE SERVICINGTHIS CHASSIS,READ THE "X-RAY RADIATION PRECAUTION","SAFETYPRECAUTION"AND "PRODUCTSAFETY NOTICE"ON THE MANUAL FOR THIS MODEL.
CAUTION :The international hazard symbols "*"in the schematicdiagram and the partslistdesignate componentswhich have special characteristics importantfor safety and should be replaced only with types identical to those in theoriginal circuitorspecified in the parts list. The mounting position ofreplacements is to be identical with originals.Before replacing any ofthese components,read carefully the PRODUCTSAFETY NOTICE on the MANUAL forthismodel.Do not degrade the safety ofthe receiverthrough improperservicing.
4.Voltagesread with DIGITAL MULTI-METER frompointindicated to chassing ground,using a colorbar signal with all
controlsatnormal, line voltage 120 volts.
5.Waveformsare taken receiving colorbar signal with enough sensitivity.
6.Voltage reading shown are nominal values and may vary 20% exceptH.V.
NOTE:
1.RESISTOR Resistance is shown in ohm[K = 1.000,M= 1.000.000].All resistors are 1/6Wand 5%
tolerance carbon resistor,unlessotherwise noted asthe following marks.
1 /2R = Meta l o rMeta l ox ide o f1 /2 wat t 1 /2S = Carbon comps is t ion o f1 /2 watt
1 RF = Fu se res ist or of 1 wa tt 10 W= Ceme nt of 10 wat t
K = 10% G= 2% F= 1%
2.CAPACITOR Unless otherwise noted in schematic,all capacitorvalues less than 1 are expressed in
?F,and the valuesmore than 1 in pF.
All capacitorsare ceramic 50V,unless otherwise noted as the following marks.
E lec to ly ti cca pa ci tor My la rc ap ac ito r
3.The parts indicated with " * "have special characteristics,and should be replaced with identical parts only.
8/2/2019 27AF61_SCM
3/28
8/2/2019 27AF61_SCM
4/28
8/2/2019 27AF61_SCM
5/28
8/2/2019 27AF61_SCM
6/28
8/2/2019 27AF61_SCM
7/28
8/2/2019 27AF61_SCM
8/28
8/2/2019 27AF61_SCM
9/28
8/2/2019 27AF61_SCM
10/28
8/2/2019 27AF61_SCM
11/28
8/2/2019 27AF61_SCM
12/28
8/2/2019 27AF61_SCM
13/28
8/2/2019 27AF61_SCM
14/28
8/2/2019 27AF61_SCM
15/28
8/2/2019 27AF61_SCM
16/28
8/2/2019 27AF61_SCM
17/28
8/2/2019 27AF61_SCM
18/28
8/2/2019 27AF61_SCM
19/28
8/2/2019 27AF61_SCM
20/28
8/2/2019 27AF61_SCM
21/28
8/2/2019 27AF61_SCM
22/28
8/2/2019 27AF61_SCM
23/28
8/2/2019 27AF61_SCM
24/28
8/2/2019 27AF61_SCM
25/28
8/2/2019 27AF61_SCM
26/28
8/2/2019 27AF61_SCM
27/28
8/2/2019 27AF61_SCM
28/28