i723-411 www.powercommander.com 2003-2005 Ducati Monster 800S2R - PCIII USB - 1 2003-2005 Ducati M800 S2R Installation Instructions Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com Parts List 1 Power Commander 1 USB Cable 1 CD-ROM 1 Installation Guide 1 Power Adapter 1 Wire Tap 2 Power Commander Decals 2 Dynojet Decals 2 Velcro ® Strip 1 Alcohol Swab You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com The ignition MUST be turned OFF before installation! PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Button Adjustment Display Faceplate Buttons Expansion Port USB Port
5
Embed
2003-2005 Ducati M800 S2R - Power · PDF filei723-411 2003-2005 Ducati Monster 800S2R - PCIII USB - 1 2003-2005 Ducati M800 S2R Installation Instructions Dynojet Research 2191
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter1 Wire Tap2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port
1. Remove the seat
2. Lift the front of the fuel tank up.
3. Remove the left hand side cover(Fig. A).
The PCIII will be mounted behindthis cover later on.
7 Route the PCIII behind the frame tubeas in Fig. D. and route along the lefthand frame tube going towards the airbox.
PCIII harness
Fig.
G12. Plug the grey wire from the Power
Commander to the supplied wire tap(Fig. G).
Note: It is recommended to use dielectricgrease on this connection.
13. Plug the connector back onto the TPS.
Align the PCIII connector to the stockwiring harness as shown below. Thesquare edges of the PCIII connectoralign with the spring clip side of thestock wiring harness
14 Locate the stock connector for therear injector (Fig. H).
15. Unplug the connector from theinjector.
16. Plug the YELLOW colored wires fromthe Power Commander in-line of thestock connector and rear injector(Fig. J).
17. Route the ORANGE colored wires tothe right hand side of the bike. Routewires under air box and between thethrottle bodies.
18. Repeat steps 15 & 16 for the frontinjector.
Stock connector
Stock connector
PCIII connectors
19 Cut the 4 zip ties along the left handframe tube that hold the stock harnessin place. Use the supplied zip ties tosecure the PCIII harness and stockharness to the frame (Fig. K).