i713-411 www.powercommander.com 2000-2006 MV Agusta 750 - PCIII USB - 1 2000-2006 MV Agusta F4 750 Installation Instructions Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com Parts List 1 Power Commander 1 USB Cable 1 CD-ROM 1 Installation Guide 1 Power Adapter 2 Power Commander Decals 2 Dynojet Decals 2 Velcro ® Strip 1 Wire tap 1 Alcohol Swab You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com The ignition MUST be turned OFF before installation! PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Button Adjustment Display Faceplate Buttons USB Port Expansion Port
3
Embed
2000-2006 MV Agusta F4 750 - Power Commander · i713-411 2000-2006 MV Agusta 750 - PCIII USB - 1 2000-2006 MV Agusta F4 750 Installation Instructions Dynojet Research 2191 Mendenhall
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Wire tap1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1 Remove the tail section.
2 Remove the fuel tank.
3 Place the PCIII in the tail sectiontemporarily. Route the wiring harnessfrom the PCIII towards the fuel rail.Make sure to go under the subframecrossover by the battery.
4 Disconnect the stock wiring harnessfrom the fuel injector rail (Fig. A).
5 Connect the male end from the PCIIIto the stock female end that you havejust removed from the injector rail.
6 Plug the female end connectors of thePCIII to the injector rail (Fig B).
Align the PCIII connector to the stockwiring harness as shown below. Thesquare edges of the PCIII connectoralign with the spring clip side of thestock wiring harness
7 Disconnect the TPS connector on theright hand end of the throttle bodies.Locate the white wire with the greentracer (Pin “C”) Connect thesupplied wire tap to this wire. Plugthe grey wire from the PCIII to thesupplied wire tap (Fig. C).
Note: It is recommended use dielectricgrease on this connection.