2-Stage Vane Separator The Seaworth 2-Stage Separator system is designed for opera- tion in harsh marine environments. It is used on Off-Shore Platforms, air intakes on marine vessels and Coastal air intake where salt is an issue. The coalescer is also a G3 rated dust filter. Two Configurations for this item are available: (1) Vane Separator followed by Filter/Coalescer—Velocities up to 4.5m/sec. (2) Filter Coalescer followed by Vane Section—Velocities up to 6.1m/sec Seaworth 2-Stage Separators are included on the Cape Class Patrol Boats: Photo courtesy of Austal Photo courtesy of Q-West & Skipper Magazine
2
Embed
2-Stage Vane Separator - Seaworth Sheet 2 Stage.pdf · 2-Stage Vane Separator The Seaworth 2-Stage Separator system is designed for opera-tion in harsh marine environments. It is
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
2-Stage Vane Separator The Seaworth 2-Stage Separator system is designed for opera-tion in harsh marine environments. It is used on Off-Shore Platforms, air intakes on marine vessels and Coastal air intake where salt is an issue. The coalescer is also a G3 rated dust filter.
Two Configurations for this item are available:
(1) Vane Separator followed by Filter/Coalescer—Velocities up to 4.5m/sec.
(2) Filter Coalescer followed by Vane Section—Velocities up to 6.1m/sec
Seaworth 2-Stage Separators are included on the Cape Class Patrol Boats: Photo courtesy of Austal
Photo courtesy of Q-West & Skipper Magazine
GT2 Coalescer Panel:
Consists of a special polymer media sand-wiched between stainless steel welded wire mesh. This structure is corrugated and retained in a 316 stainless steel housing. The GT2 reduces airborne salt spray and dust contaminants down to usual design requirements. Using the Sea-worth HV2 bag or HE10 can increase salt effi-ciency to 0.0013ppm against the NGTE 30 knot aerosol.
Vane Separator:
Constructed of marine grade anodized alumini-um, the marine separator achieves maximum possible water loading with minimal weight and pressure losses. Air drawn through a series of specially designed vanes which trap water, which then drains vertically down to the drain-age channel and finally out the front drain slot or into a Manometric drain trap.
Sizing Information Width Height
Vessels Opening W H
Over Flanges W + 60mm H + 60mm
Open Face Size W - 60mm H - 130mm
Overall Depth: 110mm
This data is guideline only and is subject to change. For further information please contact Camfil New Zealand Ltd