BIMINI KIT CONTENTS Parts and components checklist Component Fabric x 1 Polyester PVC coated marine fabric Crossbars x 2 Aluminium tube Webbing Straps x 4 Heavy duty polyester Uprights x 2 Separate left & right upright sections Saddles x 4 Stainless Steel mount, Code 21012 Webbing adjusters x 4 Stainless Steel fastener, Code 21011 Snap Hooks x 4 Stainless Steel fastener, Code 21010 Deck Mounts x 2 High polymer grade mount w/screw Code 21001 Description & quantity 2 Bow Bimini Assembly Instructions Deck mounts Saddles 1.5 - 1.85M 1.5 - 1.85M open boat example Deck mounts open boat example * Use the same method to install saddles. Distance between the deck mounts and saddles depends on personal preference, but they must be between 1.5 - 1.85 M as shown... Base installation * Locate where the Bimini deck mounts will be placed. * Measure and confirm the marks for the deck mounts to make sure they are exactly opposite each other, in parallel. If not parallel, the top may look unbalanced or deformed. * Drill and secure the deck mounts using suitable hardware (not supplied) such as 6mm or 1/4” countersunk bolts (depending on your craft). Note the taper on the deck mounts, ensure they lean inwards to match the Bimini frame * Place Bimini on deck mounts as shown Taper Leans to boat * Drill and secure the saddles using suitable hardware (not supplied) - depending on your craft or preference. Secure all ends to the deck and tighten all the webbing on fabric to complete your Bimini! NOTE: Make sure all set screws are tight. Ensure webbing straps are equal length and in strong tension. BASE INSTALLATION Installing the Bimini on your vessel 4 Screws / 4 Washers Fasteners: 8G, 10mm