11. Reactions of Alkyl Halides: Nucleophilic Substitutions and Eliminations Based on McMurry’s Organic Chemistry, 6 th edition
Feb 24, 2016
11. Reactions of Alkyl Halides: Nucleophilic Substitutions and Eliminations
Based on McMurry’s Organic Chemistry, 6th edition
2
Alkyl Halides React with Nucleophiles and Bases Alkyl halides are polarized at the carbon-halide bond,
making the carbon electrophilic Nucleophiles will replace the halide in C-X bonds of
many alkyl halides(reaction as Lewis base) Nucleophiles that are also Brønsted bases can
produce elimination
3
11.1 The Discovery of the Walden Inversion In 1896, Walden showed that (-)-malic acid could be
converted to (+)-malic acid by a series of chemical steps with achiral reagents
This established that optical rotation was directly related to chirality and that it changes with chemical alteration Reaction of (-)-malic acid with PCl5 gives (+)-
chlorosuccinic acid Further reaction with wet silver oxide gives (+)-malic
acid The reaction series starting with (+) malic acid gives (-)
acid
4
Reactions of the Walden Inversion
5
Significance of the Walden Inversion The reactions alter the configuration at the chirality
center The reactions involve substitution at that center Therefore, nucleophilic substitution can
invert the configuration at a chirality center
The presence of carboxyl groups in malic acid led to some dispute as to the nature of the reactions in Walden’s cycle
6
11.2 Stereochemistry of Nucleophilic Substitution In the 1920’s and 1930’s Kenyon and
Phillips carried out a series of experiments to find out how inversion occurs and determine the precise mechanism of nucleophilic substitution reactions.
Instead of halides they used tosylates (OTos) which are better “leaving groups” than halides.
(alkyl toluene sulfonates)
7
Only the second and fifth steps are reactions at carbonSo inversion certainly occurs in these substitution steps
8
Problem 11.1
Write a stereochemical equation for this nucleophilic substitution reaction:
(S)-2-bromohexane + CH3COO-
9
11.3 Kinetics of Nucleophilic Substitution Rate is change in concentration with time Depends on concentration(s), temperature, inherent
nature of reaction (activation energy) A rate law describes relationship between the
concentration of reactants and rate of conversion to products – determined by experiment.
A rate constant (k) is the proportionality factor between concentration and rate
Example: for S P
an experiment might find
Rate = k [S] (first order)
10
Reaction Kinetics The study of rates of reactions is called kinetics Rates decrease as concentrations decrease but the
rate constant does not The rate law depends on the mechanism The order of a reaction is sum of the exponents of the
concentrations in the rate law – the example below is second orderExperiments show that for the reaction
OH- + CH3Br CH3OH + Br-
Rate = k[OH-][CH3Br]
11
11.4 The SN2 Reaction
One type of nucleophilic substitution reaction has the following characteristics:
Reaction occurs with inversion at reacting center
Follows second order reaction kinetics rate = k [Nu:-][RX] Nomenclature suggested by Hughes and
Ingold in 1937: S=substitution N (subscript) = nucleophilic 2 = bimolecular - both nucleophile and substrate in
rate determining step
12
13
SN2 Transition State
The transition state of an SN2 reaction has a planar arrangement of the carbon atom and the remaining three groups
14
15
11.5 Characteristics of the SN2 Reaction
Sensitive to steric effects Methyl halides are most reactive Primary are next most reactive Secondary might react Tertiary are unreactive by this path No reaction at C=C (vinyl halides)
16
Reactant and Transition-state Energy Levels
Higher reactant energy level (red curve) = faster reaction (smaller G‡).
Higher transition-state energy level (red curve) = slower reaction (larger G‡).
17
Steric Effects on SN2 Reactions
The carbon atom in (a) bromomethane is readily accessibleresulting in a fast SN2 reaction. The carbon atoms in (b) bromoethane (primary), (c) 2-bromopropane (secondary), and (d) 2-bromo-2-methylpropane (tertiary) are successively more hindered, resulting in successively slower SN2 reactions.
18
Steric Hindrance Raises Transition State Energy
Steric effects destabilize transition states Severe steric effects can also destabilize ground
state
Very hindered
19
Order of Reactivity in SN2
The more alkyl groups connected to the reacting carbon, the slower the reaction
20
The Nucleophile Neutral or negatively charged Lewis base Reaction increases coordination at nucleophile
Neutral nucleophile acquires positive charge Anionic nucleophile becomes neutral See Table 11-1 for an illustrative list
21
22
Relative Reactivity of Nucleophiles
Depends on reaction and conditions More basic nucleophiles react faster (for similar
structures. See Table 11-2) Better nucleophiles are lower in a column of the
periodic table Anions are usually more reactive than neutrals
23
24
The Leaving Group A good leaving group reduces the barrier to a
reaction Stable anions that are weak bases are usually
excellent leaving groups and can delocalize charge
25
Poor Leaving Groups If a group is very basic or very small, it is prevents
reaction
Problem 11.6 Rank in order of SN2 reactivityCH3Br, CH3OTs, (CH3)3Cl, (CH3)2CHCl
26
The Solvent Solvents that can donate hydrogen bonds (-OH or –
NH) slow SN2 reactions by associating with reactants Energy is required to break interactions between
reactant and solvent Polar aprotic solvents (no NH, OH, SH) form weaker
interactions with substrate and permit faster reaction
27
Problem 11.7
Benzene, ether, chloroform are not protic or very polar. How would they affect SN2 reactions?
28
29
30
31
11.6 The SN1 Reaction
Tertiary alkyl halides react rapidly in protic solvents by a mechanism that involves departure of the leaving group prior to addition of the nucleophile
Called an SN1 reaction – occurs in two distinct steps while SN2 occurs with both events in same step
If nucleophile is present in reasonable concentration (or it is the solvent), then ionization is the slowest step
Previously we learned that tertiary alkyl halides react extremely slowly in SN2 reactions. But tert-butyl bromide reacts with water 1,000,000 times faster than methyl bromide.
32
33
SN1 Energy Diagram
Step through highest energy point is rate-limiting
rate = k[RX]
34
Rate-Limiting Step The overall rate of a reaction is controlled by the rate
of the slowest step The rate depends on the concentration of the species
and the rate constant of the step The highest energy transition state point on the
diagram is that for the rate determining step (which is not always the highest barrier)
This is the not the greatest difference but the absolute highest point (Figures 11.8 – the same step is rate-determining in both directions)
35
Stereochemistry of SN1 Reaction
The planar intermediate should lead to loss of chirality A free
carbocation is achiral
Product should be racemic
36
SN1 in Reality Carbocation is biased to react on side opposite
leaving group Suggests reaction occurs with carbocation loosely
associated with leaving group during nucleophilic addition
Alternative that SN2 is also occurring is unlikely
37
Effects of Ion Pair Formation If leaving group remains
associated, then product has more inversion than retention
Product is only partially racemic with more inversion than retention
Associated carbocation and leaving group is an ion pair
38
39
11.9 Characteristics of the SN1 Reaction Tertiary alkyl halide is most reactive by
this mechanismControlled by stability of carbocation
40
Delocalized Carbocations Delocalization of cationic charge enhances stability Primary allyl is more stable than primary alkyl Primary benzyl is more stable than allyl
41
Allylic and Benzylic Halides
Allylic and benzylic intermediates stabilized by delocalization of charge (See Figure 11-13) Primary allylic and benzylic are also more reactive
in the SN2 mechanism
42
43
Effect of Leaving Group on SN1
Critically dependent on leaving group Reactivity: the larger halides ions are better
leaving groups In acid, OH of an alcohol is protonated and leaving
group is H2O, which is still less reactive than halide p-Toluensulfonate (TosO-) is excellent leaving group
44
45
Nucleophiles in SN1
Since nucleophilic addition occurs after formation of carbocation, reaction rate is not affected normally affected by nature or concentration of nucleophile
46
Solvent Is Critical in SN1
Stabilizing carbocation also stabilizes associated transition state and controls rate
Solvation of a carbocation by water
47
Polar Solvents Promote Ionization Polar, protic and unreactive Lewis base solvents
facilitate formation of R+ Solvent polarity is measured as dielectric
polarization (P) (Table 11-3) Nonpolar solvents have low P Polar SOLVENT have high P values
48
49
Effects of Solvent on Energies Polar solvent stabilizes transition state and
intermediate more than reactant and product
50
51
52
11.10 Alkyl Halides: Elimination Elimination is an alternative pathway to substitution Opposite of addition Generates an alkene Can compete with substitution and decrease yield,
especially for SN1 processes
53
Zaitsev’s Rule for Elimination Reactions (1875) In the elimination of HX from an alkyl halide, the more
highly substituted alkene product predominates
54
55
56
Mechanisms of Elimination Reactions Ingold nomenclature: E – “elimination” E1: X- leaves first to generate a carbocation
a base abstracts a proton from the carbocation
E2: Concerted (one step) transfer of a proton to a base and departure of leaving group
57
11.11 The E2 Reaction Mechanism A proton is transferred to base as leaving group
begins to depart Transition state combines leaving of X and transfer of
H Product alkene forms stereospecifically
58
E2 Reaction Kinetics
One step – rate law has base and alkyl halide Transition state bears no resemblance to
reactant or product Rate = k[R-X][B] Reaction goes faster with stronger base,
better leaving group
59
Geometry of Elimination – E2
Antiperiplanar allows orbital overlap and minimizes steric interactions
60
E2 Stereochemistry Overlap of the developing orbital in the transition
state requires periplanar geometry, anti arrangement
Allows orbital overlap
61
Predicting Product E2 is stereospecific Meso-1,2-dibromo-1,2-diphenylethane with
base gives cis 1,2-diphenyl RR or SS 1,2-dibromo-1,2-diphenylethane
gives trans 1,2-diphenyl
62
Practice problem 11.4 E2 rxn of(1S,2S)-1,2-dibromo-1,2-diphenylethane
63
11.12 Elimination From Cyclohexanes
Abstracted proton and leaving group should align trans-diaxial to be anti periplanar (app) in approaching transition state (see Figures 11-19 and 11-20)
Equatorial groups are not in proper alignment
64
Kinetic Isotope Effect Substitute deuterium for hydrogen at position Effect on rate is kinetic isotope effect (kH/kD =
deuterium isotope effect) Rate is reduced in E2 reaction
Heavier isotope bond is slower to break Shows C-H bond is broken in or before rate-
limiting step
65
11.14 The E1 Reaction Competes with SN1 and E2 at 3° centers V = k [RX]
66
Stereochemistry of E1 Reactions E1 is not stereospecific and there is no requirement
for alignment Product has Zaitsev orientation because step that
controls product is loss of proton after formation of carbocation
67
Comparing E1 and E2 Strong base is needed for E2 but not for E1 E2 is stereospecifc, E1 is not E1 gives Zaitsev orientation
68
Homework problems for Chapter 11
21 – 23, 25 (SN2 only), 26, 27, 29 – 32, 36, 37, 39 – 41
OWL for Chapter 11 due Jan 22
Problems 24, 25, 28, 34, 35, 38, 39, 46, 47, 49, 50, 55, 59, 62, 65
69
11.15 Summary of Reactivity: SN1, SN2, E1, E2 Alkyl halides undergo different reactions in
competition, depending on the reacting molecule and the conditions
Based on patterns, we can predict likely outcomes (See Table 11.4)
70
71
72
73
74