100mm Lens Adaptor for Olympus 7-14mm

LEE Filters 100mm SystemOlympus 7-14mm Pro f2.8 lens adaptor

Assembly Instructions

The Lens Adaptor is made up of three rings:1. Front Ring (with 4 positioning lugs)2. Compression Ring (blue)3. Locking Ring (fluted)All three rings are supplied screwed together, unscrew from each other before assembly.

Stage 1

To fix the Lens Adaptor, the lens must be off the camera.- once fitted, it can be left permanently in place.

Before attaching to the lens, place the locking ring over the blue compression ring.

Stage 2

1

2

Position the front ring, with the lugs nearest to the lens – the ring will only fit correctly in one orientation as the lugs are asymmetric.

Stage 3

1 2

You now need to turn the lens face down; this is easier to achieve if you use the original cap to pin the front ring in position.

Note: the cap will not lock in place, it merely holds the front ring in the correct position for stage 5.

Stage 4

1 2

Introduce the locking ring and compression ring from the rear of the lens while still holding the lens by the cap.

Stage 5

You should then be able to tighten the lock ring onto the front ring – do this until finger tight, there is no need to use excessive force and the ring should then be locked in place with no movement or slack. 2

1

You are now ready to attach the LEE filter holder when needed.

When finished, use the white LEE lens cap (supplied) to protect the front element of the lens.

Stage 6