1 Karthik Visvanathan, Farah Shariff, Seow Yuen Yee and Amar S. Basu Karthik Visvanathan, Farah Shariff, Seow Yuen Yee and Amar S. Basu Department of Mechanical Engineering, University of Michigan, Ann Department of Mechanical Engineering, University of Michigan, Ann Arbor, USA Arbor, USA Department of Electrical Engineering and Computer Science, Department of Electrical Engineering and Computer Science, University of Michigan, Ann Arbor, USA University of Michigan, Ann Arbor, USA 指指指指 指指指 指指 : 指指指指 指指指 指指 : 指指 指指指 : 指指 指指指 :
18
Embed
1 Karthik Visvanathan, Farah Shariff, Seow Yuen Yee and Amar S. Basu Department of Mechanical Engineering, University of Michigan, Ann Arbor, USA Department.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
1
Karthik Visvanathan, Farah Shariff, Seow Yuen Yee and Amar S. BasuKarthik Visvanathan, Farah Shariff, Seow Yuen Yee and Amar S. BasuDepartment of Mechanical Engineering, University of Michigan, Ann Arbor, USADepartment of Mechanical Engineering, University of Michigan, Ann Arbor, USA
Department of Electrical Engineering and Computer Science, University of Michigan, Ann Arbor, Department of Electrical Engineering and Computer Science, University of Michigan, Ann Arbor, USAUSA
A similar work using isopropyl alcohol as a propellant
“Propulsion of microboats using isopropyl alcohol as a propellant”J. Micromech. Microeng. 18 (2008) 067002 (6pp)
9
ExperimentWater based mini robots for environmental sensing
applications and/or military applicationsMarangoni flow based on local thermal gradient for
propulsion and steeringCompared with solution based propulsion limited
fuel may be a challengeCompared with propeller based propulsion noise
and vibration may be a challengeIn a macro system, marangoni flow is usually
ignored; but in a micro system, marangoni flow becomes dominant
10
ExperimentSix legged design provides three DOF of
movementHigh temperature induces low surface tension,
exerting a tangential force to propel the robot
11
ExperimentLift force increases with increasing contact angle
and saturates at contact angle greater than 90°To increase lift force leg of the robot can be
covered with a hydrophobic material
12
ExperimentA 10mm x 300μm x 300μm leg with a 2mm x 200μm x 1μm heater
Minimum gap of 10mm between the legs required to prevent temperature gradient from one leg to affect the other
13
ExperimentAt 60℃ for each leg
maximum flow velocity 15.3mm/spropulsion force 0.638mN
14
ResultA H-shaped structure was constructed to test the
feasibility of the proposed mini-robotH-shaped robot tested in Fluorinert FC 3283
solution
15
ResultLinear, clockwise, counter-clockwise motion of
the H-shaped structure demonstratedSpot heated using a soldering iron, the structure
was observed to move from regions of lower surface tension (high temperature region) to higher surface tension (low temperature region)
16
Conclusion/future workThis paper reports a novel propulsion mechanism
utilizing a thermal gradient based Marangoni flows
Preliminary experiments demonstrate the feasibility of the proposed propulsion mechanism
The actual proposed device is expected to perform betterhydrophobic material will increase total lift forcepropulsion force can be increased by increasing
temperature of the heater and the number of legs
17
Reference Wikipedia “Biologically Inspired Miniature Water Strider Robot” Steve H. Suhr, Yun Seong
Song, Sang Jun Lee, and Metin Sitti, Member, IEEE “Propulsion of microboats using isopropyl alcohol as a propellant” J. Micromech.