This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Clipper CircuitClipper Circuit• Clipper circuits have the ability to Clipper circuits have the ability to ‘clip’ off a portion of the input signal ‘clip’ off a portion of the input signal without distorting the remaining part without distorting the remaining part of the alternating waveform. of the alternating waveform.
Clamper CircuitClamper Circuit• The clamping network ‘clamp’ a signal to different The clamping network ‘clamp’ a signal to different
dc level without altering the wave-shape.dc level without altering the wave-shape.
• The network will have a capacitor, a diode and a The network will have a capacitor, a diode and a resistive element.resistive element.
• The magnitude of The magnitude of R R and and C C must be chosen such must be chosen such that the time constant that the time constant t t = = RC RC is large enough to is large enough to ensure that the voltage across the capacitor does ensure that the voltage across the capacitor does not discharge significantly during the interval the not discharge significantly during the interval the diode is non-conductingdiode is non-conducting
• Used in TV receivers as a DC restorerUsed in TV receivers as a DC restorer
The circuit for a positive clamper is shown in the figure. During the negative half cycle of the input signal, the diode conducts and acts like a short circuit. The output voltage Vo 0 volts . The capacitor is charged to the peak value of input voltage Vm. and it behaves like a battery. During the positive half of the input signal, the diode does not conduct and acts as an open circuit. Hence the output voltage Vo Vm+ Vm This gives a positively clamped voltage.
During the positive half cycle the diode conducts and acts like a short circuit. The capacitor charges to peak value of input voltage Vm. During this interval the output Vo which is taken across the short circuit will be zero During the negative half cycle, the diode is open. The output voltage can be found by applying KVL.
Diode :- ClamperDiode :- ClamperThe circuit of a positively biased clamper is shown in the figure. During the negative half cycle of the input signal the diode is forward biased and acts like a short circuit. The capacitor charges to Vi + Vs . Applying the KVL to the input side
During the positive half cycle of the input signal, the diode is reverse biased and it acts as an open circuit. Hence Vs has no effect on Vo. Applying KVL around the outside loop.
LP3LP3 1919
•In the positive half cycle C gets charged through D to 10V (peak of sine wave + 5 V) with the straight plate of C at a higher potential. D Clips the output to a maximum of -5V.
•In the negative half cycle D is reverse biased. The output can reach a minimum of –15V (-VC + negative peak of sine wave).