A. To bypass effects, press the active BYPASS footswitch. The display will read “BYPASS”. B. To exit Bypass mode, press the BYPASS or any of the 1-5 footswitches. C. To use the Tuner, press and hold the BYPASS footswitch for 2 seconds. The display will briefly read “TUNER” then enter Tuner mode. D. Play a note on the guitar. The note will be shown in the display and arrows in the display will indicate if the note is sharp, flat, or in tune. E. To exit Tuner mode, press the BYPASS or any of the 1-5 footswitches. MAKING CONNECTIONS / APPLYING POWER BYPASSING EFFECTS & USING THE TUNER WHAT’S IN THE BOX • RP500 Multi-Effects Switching System & USB Recording Interface • Power Supply REGISTER YOUR PRODUCT To activate your warranty, please register at http://digitech.com/en-US/support/warranty_registration. GET X-EDIT To get the X-Edit software, visit http://digitech.com/en-US/products/RP500#downloads. GET THE OWNER’S MANUAL Scan the QR code to get the owner’s manual or visit http://digitech.com/en-US/products/RP500#documentation. 1 2 Live Application Recording / Practice Application A. Set your amp(s) to a clean tone, set the tone controls for a flat EQ response (on most amps, this would be 0 or 5 on the tone controls), turn the volume control(s) all the way down, then power off the amp(s). If connecting to a mixer, fully lower the corresponding channel fader(s). B. Make connections as shown in the diagrams to the right, depending on application type. C. Connect the included power supply to the POWER input jack and plug it into an available AC outlet. D. Set the RP500’s MASTER LEVEL control to 50. E. Power on your amp(s). While playing, slowly raise the amp volume control(s) to the desired volume. If using a mixer, adjust each channel’s gain/trim and fader controls for the desired volume. Press for Bypass, hold for Tuner E Sharp In Tune Flat